FS2003(US) Equinox Technologies, FS2003(US) Datasheet - Page 35

• Manufacturer Part Number: FS2003(US)
• Description: PROGRAMMER PORTABLE HI-SPEED ISP
• Manufacturer: Equinox Technologies
• Series: FS2003r
• Type: Portable Production ISPr

Specifications of FS2003(US)

• Mfg Application Notes: ASCII Text Control Protocol Appl Note
• Contents: Programmer, Power Supply Adapter, Software, Cables and Documentation
• For Use With/related Products: Atmel/NXP 8051 MCUs and Atmel AVR MCUs
• Other names: 483-1003

2.8 Testing the programmer hardware
a
b
c
d
32
If you have a ‘Current Limit’ on your power
supply, turn it to approximately 20mA and
then gradually increase it until the
programmer ‘FAIL’ LED starts to FLASH.
No Programming Projects Loaded
Check the programmer firmware version
Check the programmer serial number,
build revision and build date
Apply power to the programmer
NO / INVALID
PROJECT LOADED!
EQUINOX-TECH UK
FS2003 Ver:2.41
SN:619 1.01
DATE 19-1-2004
FS2003 ISP Programmer - User Guide V1.08 – 1
The LED will illuminate if a target voltage
between 3.0 and 5.0V is detected.
programmer has rebooted. *** The FAIL LED no
longer flashes with firmware version 2.46 or
greater)
show the programmer type, firmware version
etc. See 2.7(b), (c), (d).
After 2 seconds the display will update to show
the following information:
Programmer circuitry powers up to 5.0V.
Target Vcc LED illuminates
FAIL LED flashes to indicate that the
The programmer display now initialises to
•
•
•
•
•
•
•
If the programmer has never been used
before or the on-board FLASH Memory
Store has been erased, then the
programmer will display the message:
‘No / Invalid Project Loaded’. This is
normal as the programmer ‘FLASH
Memory Store’ is empty so the
programmer cannot be used in
Standalone Mode.
It is not possible to check the
programmer information until a valid
project is uploaded. Please upload a
valid project to the programmer using
EQTools and then try again.
The programmer display now shows the
programmer type and the firmware
version.
e.g. 2.37.
You can check that you have the very
latest firmware version by viewing the
‘Configit – Firmware Update Utility’ on
the Equinox website.
Serial Number (SN): eg. 619
Hardware Build Version: eg. 1.01
Build date: eg. 19 /1/2004
st
August 2008