HD64F3687GFPV Renesas Electronics America, HD64F3687GFPV Datasheet - Page 334

• Manufacturer Part Number: HD64F3687GFPV
• Description: IC H8 MCU FLASH 56K 64LQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8/300H Tinyr

Specifications of HD64F3687GFPV

• Core Processor: H8/300H
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: I²C, SCI
• Peripherals: LVD, POR, PWM, WDT
• Number Of I /o: 45
• Program Memory Size: 56KB (56K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 64-LQFP
• Package: 64LQFP
• Family Name: H8
• Maximum Speed: 20 MHz
• Operating Supply Voltage: 3.3|5 V
• Data Bus Width: 16|32 Bit
• Number Of Programmable I/os: 45
• Interface Type: I2C/SCI
• On-chip Adc: 8-chx10-bit
• Number Of Timers: 3
• For Use With: R0K436079S000BE - KIT DEV FOR H8/36079 W/COMPILER
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 16 Serial Communication Interface 3 (SCI3)
16.8
16.8.1
When framing error detection is performed, a break can be detected by reading the RxD pin value
directly. In a break, the input from the RxD pin becomes all 0s, setting the FER flag, and possibly
the PER flag. Note that as the SCI3 continues the receive operation after receiving a break, even if
the FER flag is cleared to 0, it will be set to 1 again.
16.8.2
When TE is 0, the TxD pin is used as an I/O port whose direction (input or output) and level are
determined by PCR and PDR. This can be used to set the TxD pin to mark state (high level) or
send a break during serial data transmission. To maintain the communication line at mark state
until TE is set to 1, set both PCR and PDR to 1. As TE is cleared to 0 at this point, the TxD pin
becomes an I/O port, and 1 is output from the TxD pin. To send a break during serial transmission,
first set PCR to 1 and clear PDR to 0, and then clear TE to 0. When TE is cleared to 0, the
transmitter is initialized regardless of the current transmission state, the TxD pin becomes an I/O
port, and 0 is output from the TxD pin.
16.8.3
Transmission cannot be started when a receive error flag (OER, PER, or FER) is set to 1, even if
the TDRE flag is cleared to 0. Be sure to clear the receive error flags to 0 before starting
transmission. Note also that receive error flags cannot be cleared to 0 even if the RE bit is cleared
to 0.
Rev.5.00 Nov. 02, 2005 Page 300 of 500
REJ09B0027-0500
Usage Notes
Break Detection and Processing
Mark State and Break Sending
Receive Error Flags and Transmit Operations (Clocked Synchronous Mode Only)