C8051T635-GM Silicon Laboratories Inc, C8051T635-GM Datasheet - Page 217

• Manufacturer Part Number: C8051T635-GM
• Description: IC MCU 2KB 20PIN QFN
• Manufacturer: Silicon Laboratories Inc
• Series: C8051T63xr

Specifications of C8051T635-GM

• Program Memory Type: OTP
• Program Memory Size: 2KB (2K x 8)
• Package / Case: 20-QFN
• Core Processor: 8051
• Core Size: 8-Bit
• Speed: 25MHz
• Connectivity: SMBus (2-Wire/I²C), SPI, UART/USART
• Peripherals: POR, PWM, WDT
• Number Of I /o: 17
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 3.6 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Processor Series: C8051T6x
• Core: 8051
• Data Bus Width: 8 bit
• Data Ram Size: 768 B
• Interface Type: I2C/SPI/UART
• Maximum Clock Frequency: 25 MHz
• Number Of Programmable I/os: 17
• Number Of Timers: 4
• Operating Supply Voltage: 1.8 V to 3.6 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• 3rd Party Development Tools: PK51, CA51, A51, ULINK2
• Development Tools By Supplier: C8051T630DK
• Minimum Operating Temperature: - 40 C
• Package: 20QFN EP
• Device Core: 8051
• Family Name: C8051T63x
• Maximum Speed: 25 MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 336-1464 - KIT DEV FOR C8051T630 FAMILY
• Eeprom Size: -
• Data Converters: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 336-1463-5

26.2. C2 Pin Sharing
The C2 protocol allows the C2 pins to be shared with user functions so that in-system debugging and
EPROM programming functions may be performed. This is possible because C2 communication is typi-
cally performed when the device is in the halt state, where all on-chip peripherals and user software are
stalled. In this halted state, the C2 interface can safely ‘borrow’ the C2CK (normally RST) and C2D pins. In
most applications, external resistors are required to isolate C2 interface traffic from the user application
when performing debug functions. These external resistors are not necessary for production boards. A typ-
ical isolation configuration is shown in Figure 26.1.
The configuration in Figure 26.1 assumes the following:
1. The user input (b) cannot change state while the target device is halted.
2. The RST pin on the target device is used as an input only.
Additional resistors may be necessary depending on the specific application.
/Reset (a)
Output (c)
Input (b)
Figure 26.1. Typical C2 Pin Sharing
C2 Interface Master
Rev. 1.0
C8051T630/1/2/3/4/5
C2CK
C2D
217