HD6417750SF167V Renesas Electronics America, HD6417750SF167V Datasheet - Page 687

• Manufacturer Part Number: HD6417750SF167V
• Description: MPU 3V 16K PB-FREE 208-QFP
• Manufacturer: Renesas Electronics America
• Series: SuperH® SH7750r

Specifications of HD6417750SF167V

• Core Processor: SH-4
• Core Size: 32-Bit
• Speed: 167MHz
• Connectivity: EBI/EMI, FIFO, SCI, SmartCard
• Peripherals: DMA, POR, WDT
• Number Of I /o: 28
• Program Memory Type: ROMless
• Ram Size: 24K x 8
• Voltage - Supply (vcc/vdd): 1.6 V ~ 2 V
• Oscillator Type: External
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 208-QFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -
• Data Converters: -

2. End of transfer when NMIF = 1 in DMAOR
3. End of transfer when DME = 0 in DMAOR
If the NMIF bit in DMAOR is set to 1 due to an NMI interrupt, DMA transfer is suspended on
all channels in accordance with the conditions in 1 to 4 in section 14.3.6, Ending DMA
Transfer, and the bus is passed to the CPU. Therefore, when NMIF is set to 1, the values in the
DMA source address register (SAR), DMA destination address register (DAR), and DMA
transfer count register (DMATCR) indicate the addresses for the DMA transfer to be
performed next and the remaining number of transfers. The TE bit is not set in this case.
Before resuming transfer after NMI interrupt handling is completed, 0 must be written to the
NMIF bit after first reading 1 from it. As in the case of AE being set to 1, acceptance of
external requests is suspended while NMIF is set to 1, so a DMA transfer request must be
reissued when resuming transfer. Acceptance of internal requests is also suspended, so when
resuming transfer, the DMA transfer request enable bit for the relevant on-chip peripheral
module must be cleared to 0 before the new setting is made.
If the DME bit in DMAOR is cleared to 0, DMA transfer is suspended on all channels in
accordance with the conditions in 1 to 4 in section 14.3.6, Ending DMA Transfer, and the bus
is passed to the CPU. The TE bit is not set in this case. When DME is cleared to 0, the values
in the DMA source address register (SAR), DMA destination address register (DAR), and
DMA transfer count register (DMATCR) indicate the addresses for the DMA transfer to be
performed next and the remaining number of transfers. When resuming transfer, DME must be
set to 1. Operation will then be resumed from the next transfer.
Section 14 Direct Memory Access Controller (DMAC)
Rev.7.00 Oct. 10, 2008 Page 601 of 1074
REJ09B0366-0700