XC56309VF100A Freescale Semiconductor, XC56309VF100A Datasheet - Page 36

• Manufacturer Part Number: XC56309VF100A
• Description: IC DSP 24BIT FIXED-POINT 196-BGA
• Manufacturer: Freescale Semiconductor
• Series: DSP563xxr
• Type: Fixed Pointr

Specifications of XC56309VF100A

• Interface: Host Interface, SSI, SCI
• Clock Rate: 100MHz
• Non-volatile Memory: ROM (576 B)
• On-chip Ram: 24kB
• Voltage - I/o: 3.30V
• Voltage - Core: 3.30V
• Operating Temperature: -40°C ~ 100°C
• Mounting Type: Surface Mount
• Package / Case: 196-MAPBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Signals/Connections
2-12
HRW
HRD
PB11
HDS
HWR
PB12
HCS
HA10
PB13
Signal Name
/HDS
/HRD
/HWR
Input or
Input or
Input or
Output
Output
Output
Type
Input
Input
Input
Input
Input
Input
State During
Ignored input
Ignored input
Ignored input
Table 2-11. Host Interface (Continued)
Reset
1,2
DSP56309 User’s Manual, Rev. 1
Host Read/Write
When the HI08 is programmed to interface with a single-data-strobe host
bus and the HI function is selected, this signal is the Host Read/Write
input.
Host Read Data
When the HI08 is programmed to interface with a double-data-strobe host
bus and the HI function is selected, this signal is the Host Read Data
strobe (HRD) Schmitt-trigger input. The polarity of the data strobe is
programmable, but is configured as active-low (HRD) after reset.
Port B 11
When the HI08 is configured as GPIO through the HPCR, this signal is
individually programmed through the HDDR. This input is 5 V tolerant.
Host Data Strobe
When the HI08 is programmed to interface with a single-data-strobe host
bus and the HI function is selected, this signal is the Host Data Strobe
(HDS) Schmitt-trigger input. The polarity of the data strobe is
programmable, but is configured as active-low (HDS) following reset.
Host Write Data
When the HI08 is programmed to interface with a double-data-strobe host
bus and the HI function is selected, this signal is the Host Write Data
Strobe (HWR) Schmitt-trigger input. The polarity of the data strobe is
programmable, but is configured as active-low (HWR) following reset.
Port B 12
When the HI08 is configured as GPIO through the HPCR, this signal is
individually programmed through the HDDR. This input is 5 V tolerant.
Host Chip Select
When the HI08 is programmed to interface with a non-multiplexed host
bus and the HI function is selected, this signal is the Host Chip Select
(HCS) input. The polarity of the chip select is programmable, but is
configured active-low (HCS) after reset.
Host Address 10
When the HI08 is programmed to interface with a multiplexed host bus
and the HI function is selected, this signal is line 10 of the Host Address
bus.
Port B 13
When the HI08 is configured as GPIO through the HPCR, this signal is
individually programmed through the HDDR. This input is 5 V tolerant.
Signal Description
Freescale Semiconductor