XK-Z11-M Digi International, XK-Z11-M Datasheet - Page 123

• Manufacturer Part Number: XK-Z11-M
• Description: ZIGBEE MODULE DEVELOPMENT KIT
• Manufacturer: Digi International
• Series: XBee™r
• Type: Transceiver, 802.15.4/ZigBeer

Specifications of XK-Z11-M

• Frequency: 2.4GHz
• For Use With/related Products: XBee Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1184

© 2010 Digi International, Inc.
XBee®/XBee‐PRO® ZB RF Modules
A
P
I
P
a
c
k
e
t
Start Delimiter
Length
Frame-specific Data
Checksum
Frame Type
Frame ID
64-bit Destination
Address
16-bit Destination
Network Address
Source Endpoint
Destination Endpoint
Cluster ID
Profile ID
Broadcast Radius
Transmit Options
Data Payload
Frame Fields
Transaction Sequence
Number
ZDO Payload
Offset Example
MSB 13 0xFF
MSB 17 0x00
MSB 19 0x00
LSB 14 0xFE
LSB 18 0x05
LSB 20 0x00
MSB 1 0x00
MSB 5 0x00
LSB 2 0x17
10 0x00
12 0xFF
15 0x00
16 0x00
21 0x00
22 0x00
23 0x01
24 0x34
25 0x12
26 0xA6
11 0xFF
0 0x7E
3 0x11
4 0x01
6 0x00
7 0x00
8 0x00
9 0x00
Number of bytes between the length and the checksum
Identifies the UART data frame for the host to correlate
with a subsequent transmit status. If set to 0, no transmit
status frame will be sent out the UART.
64-bit address of the destination device (big endian byte
order). For unicast transmissions, set to the 64-bit
address of the destination device, or to
0x0000000000000000 to send a unicast to the
coordinator. Set to 0x000000000000FFFF for broadcast.
16-bit address of the destination device (big endian byte
order). Set to 0xFFFE for broadcast, or if the 16-bit
address is unknown.
Set to 0x00 for ZDO transmissions (endpoint 0 is the
ZDO endpoint).
Set to 0x00 for ZDO transmissions (endpoint 0 is the
ZDO endpoint).
Set to the cluster ID that corresponds to the ZDO
command being sent.
0x0005 = Active Endpoints Request
Set to 0x0000 for ZDO transmissions (Profile ID 0x0000
is the ZigBee Device Profile that supports ZDOs).
Sets the maximum number of hops a broadcast
transmission can traverse. If set to 0, the transmission
radius will be set to the network maximum hops value.
All bits must be set to 0.
The required payload for a ZDO command. All multi-byte
ZDO parameter values (u16, u32, 64-bit address) must
be sent in little endian byte order.
The Active Endpoints Request includes the following
payload:
[16-bit NwkAddrOfInterest]
Note the 16-bit address in the API example (0x1234) is
sent in little endian byte order (0x3412).
0xFF minus the 8 bit sum of bytes from offset 3 to this
byte.
Description
122