20-101-1221 Rabbit Semiconductor, 20-101-1221 Datasheet - Page 22

• Manufacturer Part Number: 20-101-1221
• Description: RCM4400W (JAPAN TELEC CERTIFIED)
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore®r

Specifications of 20-101-1221

• Frequency: 2.4GHz
• Modulation Or Protocol: 802.11 b
• Power - Output: 16dBm
• Voltage - Supply: 3.3V
• Current - Receiving: 450mA
• Current - Transmitting: 450mA
• Data Interface: Connector, 2 x 25 Header
• Memory Size: 512K Flash, 1MB SRAM
• Antenna Connector: SMA
• Operating Temperature: -20°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Sensitivity: -
• Data Rate - Maximum: -
• Other names: 316-1147

2.3.1 Troubleshooting
If you receive the message
assigned to the USB programming cable was identified and set up in Dynamic C as
described in the preceding section.
If you receive the message No Rabbit Processor Detected, the programming
cable may be connected to the wrong COM port, a connection may be faulty, or the target
system may not be powered up. First, check to see that the power LED on the Prototyping
Board is lit. If the LED is lit, check both ends of the programming cable to ensure that it is
firmly plugged into the PC and the programming header on the RCM4400W with the
marked (colored) edge of the programming cable towards pin 1 of the programming
header. Ensure that the module is firmly and correctly installed in its connectors on the
Prototyping Board.
If Dynamic C appears to compile the BIOS successfully, but you then receive a communi-
cation error message when you compile and load a sample program, it is possible that your
PC cannot handle the higher program-loading baud rate. Try changing the maximum
download rate to a slower baud rate as follows.
• Locate the
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the
Press
compiled successfully
16
Options > Project Options
to save.
Options > Project Options
<Ctrl-Y>
Serial Options
Serial Options
to force Dynamic C to recompile the BIOS. You should receive a
Could Not Open Serial Port
message once this step is completed successfully.
dialog on the “Communications” tab in the Dynamic C
dialog on the “Communications” tab in the Dynamic C
menu. Select a slower Max download baud rate. Click
menu. Choose a lower debug baud rate. Click
, check that the COM port
RabbitCore RCM4400W
OK
Bios
to save.
OK