GS-BT2416C2.AT1 STMicroelectronics, GS-BT2416C2.AT1 Datasheet - Page 16

• Manufacturer Part Number: GS-BT2416C2.AT1
• Description: BLUETOOTH CLASS 2 MODULE SPP
• Manufacturer: STMicroelectronics

Specifications of GS-BT2416C2.AT1

• Frequency: 2.4GHz
• Data Rate - Maximum: 721kbps
• Modulation Or Protocol: Bluetooth v1.2, Class 2
• Power - Output: 0dBm
• Sensitivity: -74dBm
• Voltage - Supply: 3.3V
• Current - Receiving: 50mA
• Current - Transmitting: 90mA
• Data Interface: PCB, Surface Mount
• Memory Size: 4Mb Flash, 64kBytes RAM
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -20°C ~ 70°C
• Package / Case: Module
• Processor Series: STLC2500
• Wireless Frequency: 2.4 GHz to 2.5 GHz
• Interface Type: SPI, I2C, UART, PCM
• Data Rate: 721 Kbps
• Modulation: USB, UART, PCM
• For Use With: 497-6224 - DEMO BOARD FOR GS-BT2416C2.ATI497-6223 - DEMO BOARD FOR GS-BT2416C2.H497-5792 - BOARD DEMO FOR CLASS 1 MODULES
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-5791

AT command
A.3
16/32
Moreover it is possible to store a startup commands sequence directly into flash memory.
The sequence can be long up to 512bytes. If a macro sequence is present, in startup phase,
some OK events are generated, one for every command of the sequence, before the
+READY event.
This behavior can be avoided setting a AT+ECHO=OFF command starting the macro
(avoiding the +READY too). The sequence execution is stoppable changing the state of
GPIO3 in startup phase.
Interfaces
The module must be controlled by an external MCU using the UART and 2 GPIOs.
●
When these settings are changed by the AT+UARTSETUP command, they are stored in the
flash memory to be reloaded when the module is powered up the next time.
●
●
If GPIO3 is set to low, the module switches its mode of operation to COMMAND MODE.
UART: used to control the module with AT commands (COMMAND MODE), or
send/receive serial data to be transmitted over the SPP Bluetooth link (DATA MODE).
The first time that the module is powered up, the default UART settings are as following
(saved in flash memory):
GPIO1: configured as output. GPIO1 is high when an SPP Bluetooth link to a remote
device is present. GPIO1 is low when no Bluetooth link is present.
GPIO3: configured as input. If GPIO3 is set to high the module switches its mode of
operation to DATA MODE.
Baud rate: (bps) 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
GS-BT2416C2.AT1