ML610Q432A-NNNTC03A7 Rohm Semiconductor, ML610Q432A-NNNTC03A7 Datasheet - Page 48

• Manufacturer Part Number: ML610Q432A-NNNTC03A7
• Description: MCU 8BIT 64K FLASH 128-TQFP
• Manufacturer: Rohm Semiconductor

Specifications of ML610Q432A-NNNTC03A7

• Core Processor: nX-U8/100
• Core Size: 8-Bit
• Speed: 4.2MHz
• Connectivity: I²C, SSP, UART/USART
• Peripherals: LCD, Melody Driver, POR, PWM, WDT
• Number Of I /o: 14
• Program Memory Size: 64KB (32K x 16)
• Program Memory Type: FLASH
• Ram Size: 3K x 8
• Voltage - Supply (vcc/vdd): 1.1 V ~ 3.6 V
• Data Converters: A/D 2x12b, 2x24b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 70°C
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

4.2.2
stop code acceptor is enabled. When the STP bit of the standby control register (SBYCON) is set to “1” in this state,
Address: 0F008H
Access: W
Access size: 8 bits
Initial value: ⎯ (Undefined)
STPACP is a write-only special function register (SFR) that is used for setting a STOP mode.
When STPACP is read, “00H” is read.
When data is written to STPACP in the order of “5nH”(n: an arbitrary value) and “0AnH”(n: an arbitrary value), the
the mode is changed to the STOP mode. When the STOP mode is set, the STOP code acceptor is disabled.
When another instruction is executed between the instruction that writes “5nH” to STPACP and the instruction that
writes “0AnH”, the stop code acceptor is enabled after “0AnH” is written. However, if data other than “0AnH” is
written to STPACP after “5nH” is written, the “5nH” write processing becomes invalid so that data must be written
again starting from “5nH”.
During a system reset, the stop code acceptor is disabled.
Note:
The STOP code acceptor can not be enabled on the condition of that both any interrupt enable flag and the
corresponding interrupt request flag are “1”(An interrupt request occurrence with resetting MIE flag will have the
condition).
Initial value
STPACP
W
Stop Code Acceptor (STPACP)
―
―
W
7
―
―
W
6
―
―
W
5
―
W
―
4
4 – 3
―
W
―
3
ML610Q431/ML610Q432 User’s Manual
Chapter 4 MCU Control Function
―
W
―
2
―
―
W
1
―
―
W
0