C500CP131 Omron, C500CP131 Datasheet - Page 91

• Manufacturer Part Number: C500CP131
• Description: C-SERIES SPECIAL I/O UNIT
• Manufacturer: Omron

Specifications of C500CP131

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Programming in Ladder Form
Continue Operation
Example
1, 2, 3...
Note A program error will occur if lines are connected with the Line Connect operation,
The continue operation is used to continue an instruction line when the maxi-
mum number of conditions already exists on an instruction line.
Up to 9 conditions and 1 OUT instruction can be connected in a single line. Few-
er instructions can be written if operands are required, such as for TIM and ad-
vanced instructions. If all required instructions cannot be written in a single line,
use the continue operation to link it to the next line.
The number of inputs permitted on any line depends on the number of operands
in the instructions. The limits are summarized in the following table. Here, only
operand placed directly on the instruction line are counted; the operand bits for
conditions are not counted.
The following procedure shows how to add a condition (000010) as the 10th con-
dition in the instruction line.
as shown in the following diagram. Use the continue operation instead.
0
1
2
3
3. Move the cursor to the end of the connection and press the Enter Key.
1. Move the cursor to the 10th column (extreme right). The continue operation
2. Press (F7,) 10, and Enter to enter the condition.
Number of operands
can only be used when the cursor is in the 10th column.
The continue operation symbols will be displayed and the conditions in col-
umns 9 and 10 will be displayed on the next line.
I0000
10
9
7
5
4
Wrong
Conditions per line
Plus OUT
–––
–––
–––
Cursor
Comments
Section 3-5
85