ISP1508BET STEricsson, ISP1508BET Datasheet - Page 2

• Manufacturer Part Number: ISP1508BET
• Manufacturer: STEricsson

Specifications of ISP1508BET

• Lead Free Status / RoHS Status: Supplier Unconfirmed

1. General description
2. Features
The ISP1508 is a UTMI+ Low Pin Interface (ULPI) Universal Serial Bus (USB) transceiver
that is fully compliant with Universal Serial Bus Specification Rev. 2.0 , On-The-Go
Supplement to the USB 2.0 Specification Rev. 1.3 and UTMI+ Low Pin Interface (ULPI)
Specification Rev. 1.1 .
The ISP1508 can transmit and receive USB data at high-speed (480 Mbit/s), full-speed
(12 Mbit/s) and low-speed (1.5 Mbit/s), and provides a pin-optimized, physical layer
front-end attachment to the USB host, peripheral or OTG controller with Single Data Rate
(SDR) or Dual Data Rate (DDR) ULPI interface. The ISP1508 can transparently transmit
and receive UART signaling.
It is ideal for use in portable electronic devices, such as mobile phones, digital still
cameras, digital video cameras, Personal Digital Assistants (PDAs) and digital audio
players. It allows USB Application-Specific Integrated Circuits (ASICs), Programmable
Logic Devices (PLDs) or any system chip set to interface with the physical layer of the
USB through an 8-pin (DDR) or 12-pin (SDR) synchronous digital interface.
The ISP1508 can interface to devices with digital I/O voltages in the range of 1.4 V to
1.95 V.
The ISP1508 is available in TFBGA36 package.
I
I
I
ISP1508A; ISP1508B
ULPI Hi-Speed Universal Serial Bus On-The-Go transceiver
Rev. 02 — 13 March 2008
Fully complies with:
Interfaces to USB host, peripheral or OTG cores; optimized for portable devices or
system ASICs with built-in ULPI link
Complete Hi-Speed USB physical front-end solution that supports high-speed
(480 Mbit/s), full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s)
N
N
N
N
N
N
N
N
N
USB: Universal Serial Bus Specification Rev. 2.0
OTG: On-The-Go Supplement to the USB 2.0 Specification Rev. 1.3
ULPI: UTMI+ Low Pin Interface (ULPI) Specification Rev. 1.1
Integrated 45
device pull-up resistor, and 15 k
Integrated parallel-to-serial and serial-to-parallel converters to transmit and receive
USB clock and data recovery to receive USB data up to 500 ppm
Insertion of stuff bits during transmit and discarding of stuff bits during receive
Non-Return-to-Zero Inverted (NRZI) encoding and decoding
Supports bus reset, suspend, resume and high-speed detection handshake (chirp)
10 % high-speed termination resistors, 1.5 k
5 % host termination resistors
Product data sheet
5 % full-speed