CYP15G0401DXB-BGXC Cypress Semiconductor Corp, CYP15G0401DXB-BGXC Datasheet - Page 33

• Manufacturer Part Number: CYP15G0401DXB-BGXC
• Description: IC TXRX HOTLINK 256LBGA
• Manufacturer: Cypress Semiconductor Corp
• Series: HOTlink II™r
• Type: Transceiverr

Specifications of CYP15G0401DXB-BGXC

• Package / Case: 256-LBGA Exposed Pad, 32-HLBGA
• Number Of Drivers/receivers: 4/4
• Protocol: Multiprotocol
• Voltage - Supply: 3.135 V ~ 3.465 V
• Mounting Type: Surface Mount
• Product: PHY
• Data Rate: 1500 MBd
• Supply Voltage (max): 3.465 V
• Supply Voltage (min): 3.135 V
• Supply Current: 1.06 A
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• Number Of Channels: 4
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: CYP15G0401DX-EVAL - IC TXRX HOTLINK 256-BGA
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Document #: 38-02002 Rev. *L
BIST Status State Machine
When a receive path is enabled to look for and compare the
received data stream with the BIST pattern, the RXSTx[2:0]
bits identify the present state of the BIST compare operation.
The BIST state machine has multiple states, as shown in
Figure 2 and Table 24. When the receive PLL detects an
out-of-lock condition, the BIST state is forced to the
Start-of-BIST state, regardless of the present state of the BIST
state machine. If the number of detected errors ever exceeds
the number of valid matches by greater than sixteen, the state
machine is forced to the WAIT_FOR_BIST state where it
monitors the interface for the first character (D0.0) of the next
BIST sequence. Also, if the Elasticity Buffer ever hits an
overflow/underflow condition, the status is forced to the
BIST_START until the buffer is recentered (approximately nine
character periods).
To ensure compatibility between the source and destination
systems when operating in BIST modes, the sending and
receiving ends of the link must use the same receive clock
setup. (RXCKSEL = MID or RXCKSEL ≠ MID).
JTAG Support
The CYP(V)(W)15G0401DXB contains a JTAG port to allow
system level diagnosis of device interconnect. Of the available
JTAG modes, only boundary scan is supported. This capability
is present only on the LVTTL inputs, LVTTL outputs and the
REFCLK± clock input. The high-speed serial inputs and
outputs are not part of the JTAG test chain.
JTAG ID
The JTAG device ID for the CYP(V)(W)15G0401DXB is
‘1C800069’x.
Three-level Select Inputs
Each Three-level select input reports as two bits in the scan
register. These bits report the LOW, MID, and HIGH state of
the associated input as 00, 10, and 11, respectively.
CYW15G0401DXB
CYP15G0401DXB
CYV15G0401DXB
Page 33 of 53