M24C08-RMC6TG STMicroelectronics, M24C08-RMC6TG Datasheet - Page 14

• Manufacturer Part Number: M24C08-RMC6TG
• Description: 8KBIT SERIAL I2C BUS EEPROM
• Manufacturer: STMicroelectronics

Specifications of M24C08-RMC6TG

• Lead Free Status / Rohs Status: Compliant

Device operation
3.6.1
3.6.2
14/38
Byte Write
After the device select code and the address byte, the bus master sends one data byte. If
the addressed location is Write-protected, by Write Control (WC) being driven High, the
device replies to the data byte with NoAck, as shown in
modified. If, instead, the addressed location is not Write-protected, the device replies with
Ack. The bus master terminates the transfer by generating a Stop condition, as shown in
Figure
Page Write
The Page Write mode allows up to 16 bytes to be written in a single Write cycle, provided
that they are all located in the same page in the memory: that is, the most significant
memory address bits are the same. If more bytes are sent than will fit up to the end of the
page, a condition known as ‘roll-over’ occurs. This should be avoided, as data starts to
become overwritten in an implementation dependent way.
The bus master sends from 1 to 16 bytes of data, each of which is acknowledged by the
device if Write Control (WC) is Low. If the addressed location is Write-protected, by Write
Control (WC) being driven High, the device replies to the data bytes with NoAck, as shown
in
byte address counter (the 4 least significant address bits only) is incremented. The transfer
is terminated by the bus master generating a Stop condition.
Figure
8.
7, and the locations are not modified. After each byte is transferred, the internal
Doc ID 5067 Rev 17
M24C16, M24C08, M24C04, M24C02, M24C01
Figure
7, and the location is not