PCD3316T NXP Semiconductors, PCD3316T Datasheet - Page 5
![no-image](/images/manufacturer_photos/0/4/487/nxp_semiconductors_sml.jpg)
PCD3316T
Manufacturer Part Number
PCD3316T
Description
Manufacturer
NXP Semiconductors
Datasheet
1.PCD3316T.pdf
(30 pages)
Specifications of PCD3316T
Process Technology
CMOS
Operating Frequency (max)
3580kHz
Mounting
Surface Mount
Lead Free Status / Rohs Status
Supplier Unconfirmed
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
PCD3316T
Manufacturer:
INFINEON
Quantity:
6 897
Company:
Part Number:
PCD3316T/2
Manufacturer:
NXPL
Quantity:
1 675
Part Number:
PCD3316T/2
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Philips Semiconductors
9397 750 04824
Product specification
7.2 CAS detection
7.3 FSK reception
They can be used for ring or line polarity reversal detection. The POL on/off bit (Mode
register 1, bit 4) must be set to enable generation of an interrupt when a polarity
change occurs. The result of the two comparators can be read in bits 7 and 6 (POL0
and POL1) of the Status register (see
for the generation of a polarity interrupt.
After a power-on reset or after enabling the CAS detector the internal registers of the
CAS detection function are initialized. The initialization takes a maximum of
100 periods of the 3.58 MHz clock.
If the CAS detection is enabled the PCD3316 will generate an interrupt (Interrupt
register, bit 1 is set) when a correct dual tone (2130 and 2750 Hz) is detected.
Interrupts will be blocked when the signal level on the CAS input is below the
threshold in the level detector.
The FSK receiver function can be enabled by setting the FSK on/off bit (Mode
register 1, bit 7).
In the FSK transmission specification of BT and Bellcore a channel seizure is
transmitted first (sequence of 1010..). After the channel seizure a block of marks and
finally the data pattern are sent (see
PCD3316 which sets the FSK-BOM Indication bit (Status register, bit 4). The
FSK-BOM Indication bit is reset when the FSK receiver is disabled.
If the FSK-BOM Indication bit is set, the FSK receiver will generate an interrupt after it
has received a complete data word. An FSK data word consists of one start bit
(space), followed by eight data bits and one stop bit (mark). Interrupts will therefore
not be generated during the channel seizure and during the block of marks. When a
valid data word has been received, FSK data is available in the FSK data register.
By clearing the FSK-BOM-mask on/off bit (Mode register 1, bit 6), the FSK receiver
will not wait with the generation of interrupts until a Begin Of Mark (BOM) has been
detected but will handle the channel seizure as normal data. The block of marks
which is a string of logic 1 will still not generate interrupts because there are no start
bits.
After the generation of an interrupt the IRQ pin will become active (see
the FSK Interrupt bit is set (Interrupt register, bit 5). The received data is available in
the FSK data register.
width
Fig 3. FSK transmission specification.
FSK-BOM
11 March 1999
channel seizure
FSK transmission
Figure
Section
mark
3). These mark bits are detected by the
7.4). The 3.58 MHz clock is not needed
data
© Philips Electronics N.V. 1999. All rights reserved.
MBH979
PCD3316
CIDCW receiver
Figure
4), and
5 of 30