AT32UC3B0256 Atmel Corporation, AT32UC3B0256 Datasheet - Page 358

• Manufacturer Part Number: AT32UC3B0256
• Manufacturer: Atmel Corporation

Specifications of AT32UC3B0256

• Flash (kbytes): 256 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 60 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 44
• Ext Interrupts: 44
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 4
• Twi (i2c): 1
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Operating Voltage (vcc): 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 10
• Output Compare Channels: 16
• Input Capture Channels: 6
• Pwm Channels: 13
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

22.6
22.6.1
22.6.2
22.6.3
32059L–AVR32–01/2012
Product Dependencies
I/O Lines
Clocks
Interrupts
In order to use this module, other parts of the system must be configured correctly, as described
below.
The USB_VBOF and USB_ID pins are multiplexed with I/O Controller lines and may also be
multiplexed with lines of other peripherals. In order to use them with the USB, the user must first
configure the I/O Controller to assign them to their USB peripheral functions.
If USB_ID is used, the I/O Controller must be configured to enable the internal pull-up resistor of
its pin.
If USB_VBOF or USB_ID is not used by the application, the corresponding pin can be used for
other purposes by the I/O Controller or by other peripherals.
The clock for the USBB bus interface (CLK_USBB) is generated by the Power Manager. This
clock is enabled at reset, and can be disabled in the Power Manager. It is recommended to dis-
able the USBB before disabling the clock, to avoid freezing the USBB in an undefined state.
The 48 MHz USB clock is generated by a dedicated generic clock from the Power Manager.
Before using the USB, the user must ensure that the USB generic clock (GCLK_USBB) is
enabled at 48MHz in the Power Manager.
The USBB interrupt request line is connected to the interrupt controller. Using the USBB inter-
rupt requires the interrupt controller to be programmed first.
358