SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 343

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

27. Clock Generator
27.1
27.2
27.3
6249I–ATARM–3-Oct-11
Overview
Slow Clock Crystal Oscillator
Main Oscillator
The Clock Generator is made up of 2 PLLs, a Main Oscillator, and a 32,768 Hz low-power
Oscillator.
It provides the following clocks:
The Clock Generator User Interface is embedded within the Power Management Controller one
and is described in
The Clock Generator integrates a 32,768 Hz low-power oscillator. The XIN32 and XOUT32 pins
must be connected to a 32,768 Hz crystal. Two external capacitors must be wired as shown in
Figure
Figure 27-1. Typical Slow Clock Crystal Oscillator Connection
Figure 27-2
• SLCK, the Slow Clock, which is the only permanent clock within the system
• MAINCK is the output of the Main Oscillator
• PLLACK is the output of the Divider and PLL A block.
• PLLBCK is the output of the Divider and PLL B block.
27-1.
shows the Main Oscillator block diagram.
Section
28.9. However, the Clock Generator registers are named CKGR_.
XIN32
32,768 Hz
Crystal
XOUT32
GNDBU
AT91SAM9263
343