SAM9263 Atmel Corporation, SAM9263 Datasheet - Page 873

• Manufacturer Part Number: SAM9263
• Manufacturer: Atmel Corporation

Specifications of SAM9263

• Flash (kbytes): 0 Kbytes
• Pin Count: 324
• Max. Operating Frequency: 240 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 160
• Ext Interrupts: 160
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 4
• Can: 1
• Ssc: 2
• Ethernet: 1
• Sd / Emmc: 2
• Graphic Lcd: Yes
• Video Decoder: No
• Camera Interface: Yes
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 96
• Self Program Memory: NO
• External Bus Interface: 2
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Fpu: No
• Mpu / Mmu: No / Yes
• Timers: 3
• Output Compare Channels: 3
• Input Capture Channels: 3
• Pwm Channels: 4
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

43.5.2.9
43.5.2.10
43.5.2.11
873
AT91SAM9263
Transmit Data Cancellation
Endpoints Without Dual-Banks
Endpoints With Dual-Banks
Some endpoints have dual-banks whereas some endpoints have only one bank. The procedure
to cancel transmission data held in these banks is described below.
To see the organization of dual-bank availability refer to
There are two possibilities: In one case, TXPKTRDY field in UDP_CSR has already been set. In
the other instance, TXPKTRDY is not set.
There are two possibilities: In one case, TXPKTRDY field in UDP_CSR has already been set. In
the other instance, TXPKTRDY is not set.
• TXPKTRDY is not set:
• TXPKTRDY has already been set:
• TXPKTRDY is not set:
• TXPKTRDY has already been set:
– Reset the endpoint to clear the FIFO (pointers). (See,
– Clear TXPKTRDY so that no packet is ready to be sent
– Reset the endpoint to clear the FIFO (pointers). (See,
– Reset the endpoint to clear the FIFO (pointers). (See,
– Clear TXPKTRDY and read it back until actually read at 0.
– Set TXPKTRDY and read it back until actually read at 1.
– Clear TXPKTRDY so that no packet is ready to be sent.
– Reset the endpoint to clear the FIFO (pointers). (See,
Endpoint
Endpoint
Endpoint
Endpoint
Register”.)
Register”.)
Register”.)
Register”.)
Table 43-1 ”USB Endpoint
Section 43.6.9 ”UDP Reset
Section 43.6.9 ”UDP Reset
Section 43.6.9 ”UDP Reset
Section 43.6.9 ”UDP Reset
6249I–ATARM–3-Oct-11
Description”.