AD7899 Analog Devices, AD7899 Datasheet - Page 14

• Manufacturer Part Number: AD7899
• Description: 5 V Single Supply 14-Bit 400 kSPS ADC
• Manufacturer: Analog Devices

Specifications of AD7899

• Resolution (bits): 14bit
• # Chan: 1
• Sample Rate: 400kSPS
• Interface: Par
• Analog Input Type: SE-Bip,SE-Uni
• Ain Range: Bip (Vref),Bip (Vref) x 2,Bip (Vref) x 4,Bip 10V,Bip 2.5V,Bip 5.0V,Uni (Vref),Uni (Vref) x 2,Uni 2.5V,Uni 5.0V
• Adc Architecture: SAR
• Pkg Type: SOIC,SOP

AD7899
MICROPROCESSOR INTERFACING
The high-speed parallel interface of the AD7899 allows easy
interfacing to most DSPs and microprocessors. The AD7899
interface of the AD7899 consists of the data lines (DB0 to DB13),
CS, RD, and BUSY/EOC.
AD7899–ADSP-21xx Interface
Figure 14 shows an interface between the AD7899 and the
ADSP-21xx. The CONVST signal can be generated by the
ADSP-21xx or from some other external source. Figure 14 shows
the CS being generated by a combination of the DMS signal and
the address bus of the ADSP-21xx. In this way the AD7899 is
mapped into the data memory space of the ADSP-21xx.
The AD7899 BUSY/EOC line provides an interrupt to the
ADSP-21xx when the conversion is complete. The conversion
result can then be read from the AD7899 using a read operation.
The AD7899 is read using the following instruction
where MR0 is the ADSP-21xx MR0 register and ADC is the
AD7899 address.
V
IN
AD7899
DB0–DB13
BUSY/EOC
CONVST
CS
RD
MR0 = DM(ADC)
ADDRESS
DECODE
A0–A13
D8–D21
IRQn
DT1/F0
DMS
RD
ADSP-21xx
AD7899–TMS320C5x Interface
Figure 15 shows an interface between the AD7899 and the
TMS320C5x. As with the previous interfaces, conversion can be
initiated from the TMS320C5x or from an external source and
the processor is interrupted when the conversion sequence is
completed. The CS signal to the AD7899 derived from the DS
signal and a decode of the address bus. This maps the AD7899
into external data memory. The RD signal from the TMS320 is
used to enable the ADC data onto the data bus. The AD7899 has
a fast parallel bus so there are no wait state requirements. The
following instruction is used to read the conversion results from
the AD7899:
where D is Data Memory address and ADC is the AD7899
address.
V
IN
AD7899
BUSY/EOC
DB0–DB13
CONVST
CS
RD
IN D,ADC
ADDRESS
DECODE
A0–A13
DS
RD
D0–D13
INTn
PA0
TMS320C5x