STM8S207RB STMicroelectronics, STM8S207RB Datasheet - Page 51

• Manufacturer Part Number: STM8S207RB
• Description: Performance line, 24 MHz STM8S 8-bit MCU, up to 128 Kbytes Flash, integrated EEPROM
• Manufacturer: STMicroelectronics

Specifications of STM8S207RB

• Max Fcpu: up to 24 MHz, 0 wait states @ fCPU≤ 16 MHz
• Program: up to 128 Kbytes Flash; data retention 20 years at 55 °C after 10 kcycles
• Data: up to 2 Kbytes true data EEPROM; endurance 300 kcycles
• Ram: up to 6 Kbytes
• Advanced Control Timer: 16-bit, 4 CAPCOM channels, 3 complementary outputs, dead-time insertion and flexible synchronization

STM8S207xx, STM8S208xx
10
10.1
10.1.1
10.1.2
10.1.3
10.1.4
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100 % of the devices with an ambient temperature at T
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean ± 3 Σ).
Typical values
Unless otherwise specified, typical data are based on T
only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ± 2 Σ)
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Typical current consumption
For typical current consumption measurements, V
together in the configuration shown in
Figure 9.
Supply current measurement conditions
5 V or 3.3 V
Doc ID 14733 Rev 12
A
Figure
9.
DD
V
V
V
V
V
V
DD
DDA
DDIO
SS
SSA
SSIO
, V
A
A
DDIO
SS
= 25 °C and T
= 25 °C, V
.
.
and V
Electrical characteristics
DDA
DD
= 5 V. They are given
A
are connected
= T
Amax
(given by
51/103