EMS6500 EM Microelectronic, EMS6500 Datasheet - Page 24

• Manufacturer Part Number: EMS6500
• Description: Microcontroller Development System 4-bit (Emmon), Simulators 4-bit
• Manufacturer: EM Microelectronic

Copyright  2003, EM Microelectronic-Marin SA
2.9.1.1. Execution toolbar
2.9.1.1.1.
2.9.1.1.2.
2.9.1.1.3.
The execution toolbar contains all the buttons necessary for the control of the VICE /
ICE as well as showing the VICE / ICE break states.
This button shows the state of the connection between the emulator control window
and the in-circuit emulator. When the in-circuit interface is selected the control
window tries to connect itself to the in-circuit emulator using the communication
parameters specified in the ICE config menu options. If it does not succeed, the
control window remains unconnected. The user can connect and disconnect the
Monitor by clicking on this button. This button is not available during virtual
emulation.
This button opens a dialogue box which allows the user to select the binary file
which will be loaded into the emulator control panel. By default the binary is that
defined in the project definition file. However, it is possible to override this selection
and load any binary file which has been assembled using the EM66xx assembler.
Once the binary file is selected the source code buffer of the controlled is filled with
the corresponding source of the binary file. It should be noted that every time a
program is reassembled it should be reloaded into the emulator control window
before the program changes take effect.
This button downloads the source code buffer in to the in-circuit emulator. It also
sets any breakpoints or trace points set by the programmer. It should be noted that
every time a new or modified program is loaded into the emulator control window
source buffer it must be downloaded into the in-circuit emulator before any
modifications will take affect. The down loading of a program does not reset the
state of the emulator. Consequently it is necessary to reset the program with the
« Reset Execution Button » if the program is to be restarted.
Download program to emulator (ICE ONLY)
Load a binary file into the emulator control window
Connect/Disconnect Button (ICE ONLY)
Fig. 12 The emulator control bar
16
Development System
www.emmicroelectronic.com
EM66xx
Binder 4.3-01/03 Rev. B/495