EMS6500 EM Microelectronic, EMS6500 Datasheet - Page 29

• Manufacturer Part Number: EMS6500
• Description: Microcontroller Development System 4-bit (Emmon), Simulators 4-bit
• Manufacturer: EM Microelectronic

EM66xx
Development System
2.9.1.3.2. Activating / Deactivating Instruction Breakpoints
Instruction breakpoints can be set by simply clicking in the column « B » on the line
where the breakpoint is required. When a breakpoint is set it is indicated by a cross
in the « B » column as shown below.
Fig. 14 Setting instruction breakpoints in the emulator control panel
To remove an instruction break point simply click in the « B » column to toggle the
instruction break function. It should be noted that for instruction breakpoints to be
active they should be globally enabled using the « Instruction Break Enable Button »
in the Execution toolbar.
In order to clear all breakpoints at once, just click the mouse on the « B » (on the
title line).
When breakpoints are set with the emulator stopped, they are directly written to the
in-circuit emulator. However, if the breakpoint is set while the emulator is running it
is necessary to perform a down load of the program before the change in the
breakpoints will be implemented.
Binder 4.3-01/03 Rev. B/495
Copyright  2003, EM Microelectronic-Marin SA
21
www.emmicroelectronic.com