EMS6500 EM Microelectronic, EMS6500 Datasheet - Page 38

• Manufacturer Part Number: EMS6500
• Description: Microcontroller Development System 4-bit (Emmon), Simulators 4-bit
• Manufacturer: EM Microelectronic

Copyright  2003, EM Microelectronic-Marin SA
2.9.6. In-circuit Emulator Communication Configuration
2.9.6.1. COM Port
2.9.6.2. Baud Rate
2.9.6.3. DTR CTS RTS DSR
2.9.6.4. Buffered
2.9.6.5. OK button
2.9.6.6. Cancel Button
The software development system is connected to the in-circuit emulator is by a
serial port. The serial communication parameters are set using the « Ice Config »
option in the « emulator » menu. Selection of this option activates the
communication dialogue box shown below.
Selects the serial port used for the communication with the in-circuit emulator. The
default setting is COM1
Selects the baud rate of the serial communication. The possible options are 2400,
4800, 9600, 14400 and 19200 baud. However, actually the in-circuit emulator
supports only 9600 an 19200 baud. The default setting is 19200 baud
Shows the actual state of the communication control lines
Selecting the buffered option enables the buffering of the serial communication by
the development system software. This is recommended for normal use or if
communication problems with the in-circuit emulator are encountered.
Validates the selected communication parameters. The old communication port is
closed and the selected port opened with the selected communication parameters.
Cancels any modifications and exits. The communication port remains active with
the existing parameters
Fig. 22 In-circuit emulator communication parameters
30
Development System
www.emmicroelectronic.com
EM66xx
Binder 4.3-01/03 Rev. B/495