FDC37C665IR SMSC Corporation, FDC37C665IR Datasheet - Page 112

• Manufacturer Part Number: FDC37C665IR
• Description: 3/5 Volt Advanced High-Performance Multi-Mode Parallel Port Super I/O Floppy Disk Controller with Infranred Support
• Manufacturer: SMSC Corporation

Once awake, the FDC37C665IR will reinitiate
the auto powerdown timer for 10 ms. The part
will powerdown again when all the powerdown
conditions are satisfied.
Register Behavior
Table 45 reiterates the AT and PS/2 (including
modes 30) configuration registers available. It
also shows the type of access permitted.
order to maintain software transparency, access
to all the registers must be maintained.
Table 45 shows, two sets of registers are
distinguished based on whether their access
results in the part remaining in powerdown state
or exiting it.
Access to all other registers is possible without
awakening the part.
accessed during powerdown without changing
the status of the part.
registers will reflect the true status as shown in
the register description in the FDC description.
A write to the part will result in the part retaining
the data and subsequently reflecting it when the
part awakens.
powerdown may cause an increase in the power
consumption by the part. The part will revert
back to its low power mode when the access
has been completed.
Accessing the part during
These registers can be
A read from these
As
In
112
Pin Behavior
The FDC37C665IR is specifically designed for
portable
conservation is a primary concern. This makes
the behavior of the pins during powerdown very
important.
The pins of the FDC37C665IR can be divided
into two major categories: system interface and
floppy disk drive interface. The floppy disk drive
pins are disabled so that no power will be drawn
through the part as a result of any voltage
applied to the pin within the part's power supply
range. Most of the system interface pins are left
active to monitor system accesses that may
wake up the part.
System Interface Pins
Table 46 gives the state of the system interface
pins in the powerdown state. Pins unaffected by
the powerdown are labeled "Unchanged". Input
pins are "Disabled" to prevent them from
causing currents internal to the FDC37C665IR
when they have indeterminate input values.
PC
systems
in
which
power