cs4215 Cirrus Logic, Inc., cs4215 Datasheet - Page 8

• Manufacturer Part Number: cs4215
• Description: 16-bit Multimedia Audio Codec
• Manufacturer: Cirrus Logic, Inc.

FUNCTIONAL DESCRIPTION
Overview
The CS4215 has two channels of 16-bit analog-
to-digital conversion and two channels of 16-bit
digital-to-analog conversion. Both the ADCs and
the DACs are delta-sigma converters. The ADC
inputs have adjustable input gain, while the DAC
outputs have adjustable output attenuation. Spe-
cial features include a separate microphone input
with a 20 dB programmable gain block, an op-
tional 8-bit -law or A-law encoder/decoder, pins
for two crystals to set alternative sample rates,
direct headphone drive and mono speaker drive.
Control for the functions available on the
CS4215, as well as the audio data, are communi-
cated to the device over a serial interface.
Separate pins for input and output data are pro-
vided, allowing concurrent writing to and
reading from the device. Data must be con-
tinually written for proper operation. Multiple
CS4215 devices may be attached to the same
data lines.
Analog Inputs
Figure 1, the recommended connection diagram,
shows examples of the external analog circuitry
recommended around the CS4215. An internal
multiplexer selects between line level inputs and
microphone level inputs.
Input filters using a 150
NPO capacitor to ground are required to isolate
the input op-amps from, and provide a charge re-
serve for, the switched-capacitor input of the
codec.
by a factor of two.
The HPF bit in Control Time Slot 2 provides a
high pass filter that will reduce DC offset on the
analog inputs. Using the high pass filter will
cause slight distortions at very low frequencies.
8
The RC values may be safely changed
resistor and a .01 F
Unused analog inputs that are not selected have
a very high input impedance, so they may be
tied to AGND directly. Unused analog inputs
that are selected should be tied to AGND
through a 0.1uF capacitor. This prevents any DC
current flow.
Line Level Inputs
LINL and LINR are the line level input pins.
These pins are internally biased to the CMOUT
voltage. Figure 2 shows a dual op-amp buffer
which combines level shifting with a gain of 0.5
to attenuate the standard line level of 2 V
Op-Amps
Line In
Example
Line In
LT1013
Right
Op-amps are run
from VA1, VA2 and
Left
are
AGND.
0.47 uF
0.47 uF
Line In
Line In
Right
Left
Figure 2. DC Coupled Input.
Figure 3. AC Coupled Input.
0.47 uF
20 k
20 k
0.47 uF
0.47 uF
_
+
+
_
10 k
10 k
5 k
150
150
56 pF
56 pF
0.01 uF
NPO
150
150
0.01 uF
0.01 uF
CS4215
NPO
NPO
0.47 uF
(pin 16)
(pin 18)
LINR
LINL
0.01 uF
NPO
(pin 16)
LINR
CMOUT
(pin 19)
(pin 18)
LINL
DS76F2
rms
to