mc9s12xs128 Freescale Semiconductor, Inc, mc9s12xs128 Datasheet - Page 220

• Manufacturer Part Number: mc9s12xs128
• Description: Hcs12 Microcontrollers 16-bit Automotive Microcontroller
• Manufacturer: Freescale Semiconductor, Inc

S12X Debug (S12XDBGV3) Module
6.4.4.1
On entering Final State a trigger may be issued to the trace buffer according to the trace position control
as defined by the TALIGN field (see
is cleared then the trace buffer is disabled and the transition to Final State can only generate a breakpoint
request. In this case or upon completion of a tracing session when tracing is enabled, the ARM bit in the
DBGC1 register is cleared, returning the module to the disarmed state0. If tracing is enabled, a breakpoint
request can occur at the end of the tracing session. If neither tracing nor breakpoints are enabled then when
the final state is reached it returns automatically to state0 and the debug module is disarmed.
6.4.5
The trace buffer is a 64 lines deep by 64-bits wide RAM array. The S12XDBG module stores trace
information in the RAM array in a circular buffer format. The RAM array can be accessed through a
register window (DBGTBH:DBGTBL) using 16-bit wide word accesses. After each complete 64-bit trace
buffer line is read, an internal pointer into the RAM is incremented so that the next read will receive fresh
information. Data is stored in the format shown in
DBGCNT[6:0] are incremented. Tracing of CPU12X activity is disabled when the BDM is active. Reading
the trace buffer whilst the DBG is armed returns invalid data and the trace buffer pointer is not
incremented.
6.4.5.1
Using the TALIGN bits (see
the beginning of a tracing session.
If End or Mid tracing is selected, tracing begins when the ARM bit in DBGC1 is set and State1 is entered.
The transition to Final State if End is selected signals the end of the tracing session. The transition to Final
State if Mid is selected signals that another 32 lines will be traced before ending the tracing session.
Tracing with Begin-Trigger starts at the opcode of the trigger.
6.4.5.1.1
Storing with Begin-Trigger, data is not stored in the Trace Buffer until the Final State is entered. Once the
trigger condition is met the S12XDBG module will remain armed until 64 lines are stored in the Trace
Buffer. If the trigger is at the address of the change-of-flow instruction the change of flow associated with
the trigger will be stored in the Trace Buffer. Using Begin-trigger together with tagging, if the tagged
instruction is about to be executed then the trace is started. Upon completion of the tracing session the
breakpoint is generated, thus the breakpoint does not occur at the tagged instruction boundary.
6.4.5.1.2
Storing with Mid-Trigger, data is stored in the Trace Buffer as soon as the S12XDBG module is armed.
When the trigger condition is met, another 32 lines will be traced before ending the tracing session,
irrespective of the number of lines stored before the trigger occurred, then the S12XDBG module is
disarmed and no more data is stored. Using Mid-trigger with tagging, if the tagged instruction is about to
220
Trace Buffer Operation
Final State
Trace Trigger Alignment
Storing with Begin-Trigger
Storing with Mid-Trigger
Section
S12XS Family Reference Manual, Rev. 1.10
Section
6.3.2.3”) it is possible to align the trigger with the end, the middle, or
6.3.2.3”). If TSOURCE in the trace control register DBGTCR
Table
6-40. After each store the counter register bits
Freescale Semiconductor