wm8961 Wolfson Microelectronics plc, wm8961 Datasheet - Page 42

• Manufacturer Part Number: wm8961
• Description: Ultra-low Power Stereo Codec With 1w Stereo Class D Speaker Drivers And Ground Referenced Headphone Drivers
• Manufacturer: Wolfson Microelectronics plc

w
WM8961
Figure 18 Headphone Analogue Output Stage
LDAC
RDAC
R3, ROUT1VOL[6:0]
R3, ROUT1VOL[6:0]
R2, LOUT1VOL[6:0]
R2, LOUT1VOL[6:0]
-73dB to +6dB, in
-73dB to +6dB, in
steps of 1dB
steps of 1dB
Right Headphone PGA
Left Headphone PGA
R26, ROUT1_PGA
HEADPHONE VOLUME PGA
The signal volume on HP_L and HP_R can be independently adjusted under software control by
writing to LOUT1VOL and ROUT1VOL, respectively. Note that gains over 0dB may cause clipping if
the signal is large. Any gain setting below 0101111 (minimum) mutes the output driver.
The LOUT1VOL and ROUT1VOL register writes should only be carried out after the charge pump has
been enabled, see the “Charge Pump” section for details.
A zero cross detect on the analogue output may also be enabled when changing the gain setting to
minimize audible clicks and zipper noise as the gain updates. If zero cross is enabled a timeout is also
available to update the gain if a zero cross does not occur. This function may be enabled by setting
TOEN in register R23 (17h). The timeout period is set by CLK_TO_DIV[1:0]. The volume control
PGAs are enabled using LOUT1_PGA and ROUT1_PGA.
R26, LOUT1_PGA
+
-
+
-
+
+
+
+
R61, DCS_ENA_CHAN_HPL
R61, DCS_ENA_CHAN_HPR
Analog Output Stage
Analog Output Stage
Right Headphone
Left Headphone
DC Servo
HPL_VOL[2:0]
HPR_VOL[2:0]
+
-
+
-
VPOS
VNEG
VNEG
VPOS
AGND
AGND
HP_L
HP_R
PP, August 2009, Rev 3.1
Pre-Production
42