gs8662d08bgd-400i GSI Technology, gs8662d08bgd-400i Datasheet - Page 28
![no-image](/images/manufacturer_photos/0/2/286/gsi_technology_sml.jpg)
gs8662d08bgd-400i
Manufacturer Part Number
gs8662d08bgd-400i
Description
72mb Sigmaquad-ii Tm Burst Of 4 Sram
Manufacturer
GSI Technology
Datasheet
1.GS8662D08BGD-400I.pdf
(34 pages)
IDCODE
SAMPLE-Z
JTAG TAP Instruction Set Summary
Rev: 1.02a 5/2011
Specifications cited are subject to change without notice. For latest documentation see http://www.gsitechnology.com.
Notes:
1.
2.
SAMPLE/PRELOAD
Instruction
Typically, the Boundary Scan Register is loaded with the desired pattern of data with the SAMPLE/PRELOAD command.
Then the EXTEST command is used to output the Boundary Scan Register’s contents, in parallel, on the RAM’s data output
drivers on the falling edge of TCK when the controller is in the Update-IR state.
Alternately, the Boundary Scan Register may be loaded in parallel using the EXTEST command. When the EXTEST instruc-
tion is selected, the sate of all the RAM’s input and I/O pins, as well as the default values at Scan Register locations not asso-
ciated with a pin, are transferred in parallel into the Boundary Scan Register on the rising edge of TCK in the Capture-DR
state, the RAM’s output pins drive out the value of the Boundary Scan Register location with which each output pin is associ-
ated.
The IDCODE instruction causes the ID ROM to be loaded into the ID register when the controller is in Capture-DR mode and
places the ID register between the TDI and TDO pins in Shift-DR mode. The IDCODE instruction is the default instruction
loaded in at power up and any time the controller is placed in the Test-Logic-Reset state.
If the SAMPLE-Z instruction is loaded in the instruction register, all RAM outputs are forced to an inactive drive state (high-
Z) and the Boundary Scan Register is connected between TDI and TDO when the TAP controller is moved to the Shift-DR
state.
Instruction codes expressed in binary, MSB on left, LSB on right.
Default instruction automatically loaded at power-up and in test-logic-reset state.
SAMPLE-Z
EXTEST
IDCODE
BYPASS
GSI
GSI
GSI
Code
000
001
010
100
101
011
110
111
Captures I/O ring contents. Places the Boundary Scan Register between TDI and TDO.
Captures I/O ring contents. Places the Boundary Scan Register between TDI and TDO.
Places the Boundary Scan Register between TDI and TDO.
Preloads ID Register and places it between TDI and TDO.
Places Bypass Register between TDI and TDO.
28/34
Forces all RAM output drivers to High-Z.
GSI private instruction.
GSI private instruction.
GSI private instruction.
Description
GS8662D08/09/18/36BD-400/350/333/300/250
© 2011, GSI Technology
Notes
1, 2
1
1
1
1
1
1
1