S29GL-P_12 SPANSION [SPANSION], S29GL-P_12 Datasheet - Page 41
S29GL-P_12
Manufacturer Part Number
S29GL-P_12
Description
1 Gigabit, 512 Megabit, 256 Megabit and 128 Megabit 3.0 Volt-only Page Mode Flash Memory featuring 90 nm MirrorBit Process Technology
Manufacturer
SPANSION [SPANSION]
Datasheet
1.S29GL-P_12.pdf
(81 pages)
- Current page: 41 of 81
- Download datasheet (3Mb)
October 22, 2012 S29GL-P_00_A14
7.9.3
Software Reset
Software reset is part of the command set (see
read mode and must be used for the following conditions:
Software Functions and Sample Code
Note
Base = Base Address.
The following is a C source code example of using the reset function. Refer to the Spansion Low Level Driver
User’s Guide (available on www.spansion.com) for general information on Spansion Flash memory software
development guidelines.
The following are additional points to consider when using the reset command:
This command resets the sectors to the read and address bits are ignored.
Reset commands are ignored during program and erase operations.
The reset command may be written between the cycles in a program command sequence before
If the program command sequence is written to a sector that is in the Erase Suspend mode, writing the
The reset command may be written during an Autoselect command sequence.
If a sector has entered the Autoselect mode while in the Erase Suspend mode, writing the reset command
If DQ1 goes high during a Write Buffer Programming operation, the system must write the “Write to Buffer
To exit the unlock bypass mode, the system must issue a two-cycle unlock bypass reset command
/* Example: Reset (software reset of Flash state machine) */
programming begins (prior to the third cycle). This resets the sector to which the system was writing to the
read mode.
reset command returns that sector to the erase-suspend-read mode.
returns that sector to the erase-suspend-read mode.
Abort Reset” command sequence to RESET the device to reading array data. The standard RESET
command does not work during this condition.
sequence [see Command Definitions
1. to exit Autoselect mode
2. when DQ5 goes high during write status operation that indicates program or erase cycle was not
3. exit sector lock/unlock operation.
4. to return to erase-suspend-read mode if the device was previously in Erase Suspend mode.
5. after any aborted operations
*( (UINT16 *)base_addr ) = 0x00F0;
successfully completed
Reset Command
Cycle
D a t a
S29GL-P MirrorBit
S h e e t
Operation
(LLD Function = lld_ResetCmd)
Write
on page 68
Table 7.18 Reset
®
Table 12.1 on page
Flash Family
for details].
Byte Address
Base + xxxh
69) that also returns the device to array
Word Address
Base + xxxh
00F0h
Data
41
Related parts for S29GL-P_12
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
3.0 Volt-only Page Mode Flash Memory Featuring 90 Nm Mirrorbit Process Technology
Manufacturer:
Meet Spansion Inc.
Datasheet:
Part Number:
Description:
S29GL-A MirrorBit Flash Family
Manufacturer:
SPANSION [SPANSION]
Datasheet:
Part Number:
Description:
TS 48/CIVIL/1-BIT ECC, X8 I/O AND 3V VCC SPANSION SLC NAND
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
TS 48/CIVIL/1-BIT ECC, X8 I/O AND 3V VCC SPANSION SLC NAND
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
MBM29F400TC-70PFTNSPANSION [FLASH MEMORY CMOS 4M (512K x 8/256K x 16) BIT]
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
AM29F010B70JI1 Megabit (128 K x 8-bit) CMOS 5.0 Volt-only, Uniform Sector Flash Memory
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
S29AL016D70BAI02016 MEGABIT CMOS 3.0 VOLT ONLY BOOT SECTOR FLASH MEMORY
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
S29AL016M90FAI01016 MEGABIT (2M X 8 BIT / I M X 16 BIT) 3.0 VOLT ONLY BOOT SECTOR FLASH MEMORY
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
S29AL016M90FAI02016 MEGABIT (2M X 8 BIT / I M X 16 BIT) 3.0 VOLT ONLY BOOT SECTOR FLASH MEMORY
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
Manufacturer:
SPANSION
Datasheet:
Part Number:
Description:
Manufacturer:
SPANSION
Datasheet: