PCF88332DA PHILIPS [NXP Semiconductors], PCF88332DA Datasheet - Page 24

• Manufacturer Part Number: PCF88332DA
• Description: STN RGB - 132 X 132 X 3 driver
• Manufacturer: PHILIPS [NXP Semiconductors]

Philips Semiconductors
6.2.15
The All pixels on command (DAL) can be switched off by
sending the normal display on command (NORON); (see
Section 6.2.11) or by sending the partial Display mode on
command (PTLON); see Section 6.2.10. Furthermore DAL
is left with the command DALO; see Section 6.2.14. When
DAL is active all pixels are driven, as if the display RAM
was filled with all ones (on-state). DAL does not change
the data stored in the display RAM.
Table 24 All pixels on register bits
2003 Feb 14
handbook, full pagewidth
STN RGB - 132
(1) If the initial state is Sleep_IN, the same sequence is valid, but Sleep_OUT has to be sent to see the effect on the display (after display voltage
When sending DAL after PTLON, only the pixels of partial area are driven on. When sending INVON, in Partial mode only the pixels of partial area
are inverted. INVON is over-ruled by DAL and DALO. Pixels outside partial area always stay off.
D/C
0
has settled).
A
LL PIXELS ON
7
0
effect in
full display mode
6
0
132
exit pixel on/off
scroll mode on
send SEP
Fig.6 Flowchart representation of DAL and DALO.
Initial state
send DAL/DALO
3 driver
all pixel on/off
5
1
booster on
(1)
exit pixel on/off
normal display
send NORON
4
0
24
Sleep_OUT
effect in
partial display mode
display on
When sending DAL after PTLON, only the pixels of the
partial area are driven on. When sending INVON in Partial
mode only the pixels of the partial area are inverted.
INVON is over-ruled by DAL and DALO. Pixels outside the
partial are always off. Figure 6 illustrates how DAL (all
pixels on) and DALO (all pixels off) can be used.
All pixels will be switched on regardless of the display data
RAM.
3
0
send DAL/DALO
partial mode on
exit pixel on/off
all pixel on/off
all pixel on/off
send PTLON
2
0
MGU915
1
1
Objective specification
0
1
PCF8833
DEFAULT
23H