PIC18F24J11 MICROCHIP [Microchip Technology], PIC18F24J11 Datasheet - Page 268

• Manufacturer Part Number: PIC18F24J11
• Description: 28/44-Pin, Low-Power, High-Performance USB Microcontrollers with nanoWatt XLP Technology
• Manufacturer: MICROCHIP [Microchip Technology]

PIC18F46J11 FAMILY
FIGURE 18-18:
FIGURE 18-19:
FIGURE 18-20:
DS39932D-page 268
Note 1: Port outputs are configured as displayed when
P1<D:A>
PORT Data
PORT Data
PORT Data
PORT Data
STRn
P1<D:A>
PxA Signal
PWM
CCPxM1
CCPxM0
CCPxM1
CCPxM0
2: Single PWM output requires setting at least
STRn
PWM
STRA
STRB
STRC
STRD
the CCPxCON register bits, PxM<1:0> = 00
and CCP1M<3:2> = 11.
one of the STRx bits.
PORT Data
SIMPLIFIED STEERING
BLOCK DIAGRAM
EXAMPLE OF STEERING EVENT AT END OF INSTRUCTION (STRSYNC = 0)
EXAMPLE OF STEERING EVENT AT BEGINNING OF INSTRUCTION (STRSYNC = 1)
1
0
1
0
1
0
1
0
PORT Data
PWM Period
TRIS
TRIS
TRIS
TRIS
RPn pin
RPn pin
RPn pin
RPn pin
P1n = PWM
18.5.7.1
The STRSYNC bit of the PSTRxCON register gives the
user two selections of when the steering event will
happen. When the STRSYNC bit is ‘0’, the steering
event will happen at the end of the instruction that
writes to the PSTRxCON register. In this case, the out-
put signal at the Px<D:A> pins may be an incomplete
PWM waveform. This operation is useful when the user
firmware needs to immediately remove a PWM signal
from the pin.
When the STRSYNC bit is ‘1’, the effective steering
update will happen at the beginning of the next PWM
period. In this case, steering on/off the PWM output will
always produce a complete PWM waveform.
Figures
of the PWM steering depending on the STRSYNC
setting.
P1n = PWM
18-19
Steering Synchronization
and
PORT Data
18-20
 2011 Microchip Technology Inc.
illustrate the timing diagrams
PORT Data