PIC18F24J11 MICROCHIP [Microchip Technology], PIC18F24J11 Datasheet - Page 408

• Manufacturer Part Number: PIC18F24J11
• Description: 28/44-Pin, Low-Power, High-Performance USB Microcontrollers with nanoWatt XLP Technology
• Manufacturer: MICROCHIP [Microchip Technology]

PIC18F46J11 FAMILY
FIGURE 26-2:
DS39932D-page 408
OR
PIC18LFXXJ11 Devices (Regulator Disabled):
PIC18FXXJ11 Devices (Regulator Enabled):
2.5V
C
EFC
3.3V
2.5V
3.3V
CONNECTIONS FOR THE
ON-CHIP REGULATOR
V
V
V
V
V
V
V
V
V
DD
DDCORE
SS
DD
DDCORE
SS
DD
DDCORE
SS
PIC18LFXXJ11
PIC18FXXJ11
PIC18LFXXJ11
/V
/V
/V
CAP
CAP
CAP
26.3.2
When the on-chip regulator is enabled, PIC18F46J11
family devices also have a simple brown-out capability.
If the voltage supplied to the regulator is inadequate to
maintain a minimum output level; the regulator Reset
circuitry will generate a Brown-out Reset (BOR). This
event is captured by the BOR flag bit (RCON<0>).
The operation of the BOR is described in more detail in
Section 5.4
Section 5.4.1 “Detecting
levels are specific in
Supply Voltage PIC18F46J11 Family
26.3.3
The on-chip regulator is designed to meet the power-up
requirements for the device. If the application does not
use the regulator, then strict power-up conditions must
be adhered to. While powering up, V
exceed V
26.3.4
When enabled, the on-chip regulator always consumes
a small incremental amount of current over I
includes when the device is in Sleep mode, even
though the core digital logic does not require much
power. To provide additional savings in applications
where power resources are critical, the regulator can
be configured to automatically enter a lower quiescent
draw standby mode whenever the device goes into
Sleep mode. This feature is controlled by the REGSLP
bit (WDTCON<7>,
upon entry into Sleep mode, the regulator will transition
into a lower power state. In this state, the regulator still
provides a regulated output voltage necessary to
maintain SRAM state information, but consumes less
quiescent current.
Substantial Sleep mode power savings can be
obtained by setting the REGSLP bit, but device
wake-up time will increase in order to insure the
regulator has enough time to stabilize.
DD
ON-CHIP REGULATOR AND BOR
POWER-UP REQUIREMENTS
OPERATION IN SLEEP MODE
by 0.3 volts.
“Brown-out
Section 29.1 “DC Characteristics:
Register
 2011 Microchip Technology Inc.
BOR”. The brown-out voltage
26-11). If this bit is set
Reset
DDCORE
(Industrial)”.
(BOR)”
should not
DD
. This
and