DS32508N-W Maxim Integrated, DS32508N-W Datasheet - Page 21
![no-image](/images/no-image-200.jpg)
DS32508N-W
Manufacturer Part Number
DS32508N-W
Description
Network Controller & Processor ICs
Manufacturer
Maxim Integrated
Datasheet
1.DS32512W.pdf
(130 pages)
Specifications of DS32508N-W
Part # Aliases
90-32508-NW0
- Current page: 21 of 130
- Download datasheet (2Mb)
Table 7-6. Parallel Interface Pin Descriptions
RDY/ACK
WR/R/W
GPIOAn
GPIOBn
BSWAP
D[15:0]
A[10:1]
NAME
RD/DS
A[0] /
ALE
INT
CS
TYPE
I/Opd
I/Opd
I/O
Oz
Oz
I
I
I
I
I
I
Chip Select (Active Low). This pin must be asserted to read or write internal registers. See
Section 8.8.3.
Read Enable (Active Low)/Data Strobe (Active Low)
RD
DS
the
Write Enable (Active Low)/Read/Write Select
WR
R/W: For the Motorola-style bus
with
Address Latch Enable. This pin controls a latch on the A[10:0] inputs. For a nonmultiplexed
parallel bus, ALE is wired high to make the latch transparent. For a multiplexed parallel bus, the
falling edge of ALE latches the address. See Section 8.8.3.
Address Bus (Excluding LSB). These inputs specify the address of the internal 16-bit register
to be accessed. A10 is not present on the DS32506. See Section 8.8.
A[0]: This pin is connected to the lower address bit in 8-bit bus modes
0 = Output register bits 7:0 on D[7:0]; D[15:8] high impedance
1 = Output register bits 15:8 on D[7:0]; D[15:8] high impedance
BSWAP: This pin is tied high or low in 16-bit bus modes
0 = Output register bits 15:8 on D[15:8] and bits 7:0 on D[7:0]
1 = Output register bits 7:0 on D[15:8] and bits 15:8 on D[7:0]
Data Bus. A 8-bit or 16-bit bidirectional data bus. These pins are inputs during writes to internal
registers and outputs during reads. D[15:8] are disabled (high impedance) in 8-bit bus modes
(IFSEL
modes
high. See Section 8.8.
Ready Handshake (Tri-State)/Acknowledge Handshake (Tri-State, Active Low). Tri-stated
when
RDY: Intel Mode (IFSEL = 100 or 110): RDY goes high when the read or write cycle can
progress.
ACK
progress.
Interrupt Output (Active Low, Open Drain, or Push-Pull). This pin is driven low in response
to one or more unmasked, active interrupt sources within the device. INT remains low until the
interrupt is serviced or masked. When GLOBAL.CR2:INTM = 0,
inactive (default). When INTM = 1,
when
General-Purpose I/O A. When a microprocessor interface is enabled
the “A” general-purpose I/O pin for port n. See Section 8.7.3.
General-Purpose I/O B. When a microprocessor interface is enabled
the “B” general-purpose I/O pin for port n. See Section 8.7.3. Note: GPIOB1, GPIOB2, and
GPIOB3 can also be programmed as global control/status pins.
Address Bus LSB/Byte Swap. See Section 8.8.2.
: For the Motorola-style bus
: For the Intel-style bus
: For the Intel-style bus
R/W
R/W
: Motorola Mode (IFSEL = 101 or 111): ACK goes low when the read or write cycle can
CS
RST
(IFSEL
= 10X). D[15:0] are disabled (high impedance) when
pin specifies whether the access is a read or a write. See Section 8.8.3.
= 1 indicating a read and
= 1 or
= 0. See Section 8.10.
= 11X) the upper and lower bytes can be swapped by pulling the
RST
= 0. See Section 8.8.
(IFSEL
(IFSEL
21 of 130
(IFSEL
(IFSEL
= 1X0),
= 1X0),
INT
R/W
= 1X1),
is driven high when inactive.
= 1X1),
= 0 indicating a write. See Section 8.8.3.
FUNCTION
RD
WR
is asserted to read internal registers.
DS
is asserted to write internal registers.
R/W
is asserted to access internal registers while
determines the type of bus transaction,
(IFSEL
CS
= 11X).
INT
DS32506/DS32508/DS32512
= 1 or
is high impedance when
INT
(IFSEL
(IFSEL
(IFSEL
RST
is high impedance
= 0. In 16-bit bus
≠ 000), this pin is
≠ 000), this pin is
= 10X).
BSWAP
pin
Related parts for DS32508N-W
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
![DS32508](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
Network Controller & Processor ICs 8-Port DS3-E3-STS-1 Line Interface Unit
Manufacturer:
Maxim Integrated Products
Datasheet:
![DS32508-W](/images/no-image3.png)
Part Number:
Description:
Network Controller & Processor ICs
Manufacturer:
Maxim Integrated
Datasheet:
![MAX3261CCJ](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
Single +5V, fully integrated, 1.25Gbps laser diode driver.
Manufacturer:
Maxim Integrated Products
Datasheet:
![MAX3263CAG](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
Single +5V, fully integrated, 155Mbps laser diode driver.
Manufacturer:
Maxim Integrated Products
Datasheet:
![MAX7528KCWP](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
MAX7528KCWPMaxim Integrated Products [CMOS Dual 8-Bit Buffered Multiplying DACs]
Manufacturer:
Maxim Integrated Products
Datasheet:
![MAX8809AETL+](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
VRD11/VRD10, K8 Rev F 2/3/4-Phase PWM Controllers with Integrated Dual MOSFET Drivers
Manufacturer:
Maxim Integrated Products
Datasheet:
![MAX1535CETJ+T](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
Highly Integrated Level 2 SMBus Battery Chargers
Manufacturer:
Maxim Integrated Products
Datasheet:
![DS2741N+](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
Current Monitor and Accumulator with Integrated Sense Resistor; ; Temperature Range: -40°C to +85°C
Manufacturer:
Maxim Integrated Products
![MAX13450EAUD+T](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
TSSOP 14/A°/RS-485 Transceivers with Integrated 100O/120O Termination Resis
Manufacturer:
Maxim Integrated Products
![MAX13451EAUD+T](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
TSSOP 14/A°/RS-485 Transceivers with Integrated 100O/120O Termination Resis
Manufacturer:
Maxim Integrated Products
![MAX17497BATE+](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
QFN 16/A°/AC-DC and DC-DC Peak-Current-Mode Converters with Integrated Step
Manufacturer:
Maxim Integrated Products
![MAX17502FATB+T](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
TDFN/A/65V, 1A, 600KHZ, SYNCHRONOUS STEP-DOWN REGULATOR WITH INTEGRATED SWI
Manufacturer:
Maxim Integrated Products
![MAX1978EVKIT](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
Integrated Temperature Controller f
Manufacturer:
Maxim Integrated Products
![MAX2606EUT+](/images/manufacturer_photos/0/4/417/maxim_integrated_products_tmb.jpg)
Part Number:
Description:
SOT23-6/I°/45MHz to 650MHz, Integrated IF VCOs with Differential Output
Manufacturer:
Maxim Integrated Products