HS7729KCI01H Renesas Electronics America, HS7729KCI01H Datasheet - Page 133

• Manufacturer Part Number: HS7729KCI01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS7729KCI01H

• Contents: E10A-LITE, Cable and CD-ROM
• For Use With/related Products: SH7729
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Description:
Table 4.5
Option
[Loading flash memory]
radio button
[Erasing flash memory]
radio button
[File name] edit box
[Bus width of flash
memory] list box
[Flash memory erasing
time] edit box*
[Entry point] group box
Note: Although the values that can be set are D'0 to D'65535, the TIMEOUT hours may be
Notes on using the flash memory download function
The following are notes on downloading to the flash memory.
When the flash memory download is enabled, downloading other than to the flash memory
area is disabled.
Downloading is only enabled to the flash memory area. Perform memory write or software
break only to the RAM area.
When the flash memory erase is enabled, the [Stop] button cannot stop erasing.
The entry area for the user module must be MMU-disabled space.
extended according to the set value. Therefore, it is recommended to input the minimum
value. The value to be input must only be positive integer.
[Loading flash memory] Page Options
Description
Sets Enable for flash memory downloading.
At Enable, when [File load] is selected from the [File] menu for
downloading, the write module is always called.
Enable: Download to the flash memory
Disable: Not download to the flash memory
Sets Enable for erasing before the flash memory is written.
At Enable, the erase module is called before calling the write module.
Enable: Erase the flash memory
Disable: Not erase the flash memory
Sets the write/erase module name. The file that has been set is loaded
to the RAM area before loading to the flash memory.
A maximum of 128 characters can be input for the file name.
Sets the bus width of the flash memory.
Sets the TIMEOUT value at flash memory erasing. Increase the value
if erasing requires much time; the default time is three minutes. The
radix for the input value is decimal. It becomes hexadecimal by adding
H’.
Sets the calling destination address of the write/erase module.
[All erasing module address] edit box: Inputs the calling destination
address of the erase module.
[Writing module address] edit box: Inputs the calling destination
address of the write module.
Rev. 2.0, 01/01, page 107 of 216