HS7729KCI01H Renesas Electronics America, HS7729KCI01H Datasheet - Page 230

• Manufacturer Part Number: HS7729KCI01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS7729KCI01H

• Contents: E10A-LITE, Cable and CD-ROM
• For Use With/related Products: SH7729
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6.5.4
1. When JTAG clock (TCK) is used, set the JTAG clock (TCK) frequency to lower than the
2. When the AUD clock (AUDCK) is used, set the AUD clock (AUDCK) within the range
6.5.5
1. When an odd address is set, the address is rounded down to an even address.
2. A BREAKPOINT is accomplished by replacing instructions. Accordingly, it can be set only
3. During step execution, a BREAKPOINT is disabled.
4. Condition set at Break Condition 2 are disabled when an instruction to which a
5. When execution resumes from the breakpoint address after the program execution stops at the
6. When a BREAKPOINT is set to the slot instruction of a delayed branch instruction, the PC
7. When the [Normal] option is selected in the [Memory area] group box in the [General] page of
Rev. 2.0, 01/01, page 204 of 216
frequency of half of the CPU clock.
between the quarter of the CPU clock and the CPU clock (60 MHz).
to the RAM area. However, a BREAKPOINT cannot be set to the following addresses:
BREAKPOINT has been set is executed. Do not set a BREAKPOINT to an instruction in
which Break Condition 2 is satisfied.
breakpoint, single-step execution is performed at the address before execution resumes.
Therefore, realtime operation cannot be performed.
value becomes an illegal value. Accordingly, do not set a BREAKPOINT to the slot
instruction of a delayed branch instruction.
the [Configuration] dialog box, a breakpoint is set to a physical address or a virtual address
according to the SH7729 or SH7709A MMU status during command input when the
VPMAP_SET command setting is disabled. The ASID value of the SH7729 or SH7709A
PTEH register during command input is used. When VPMAP_SET command setting is
enabled, a breakpoint is set to a physical address into which address translation is made
according to the VP_MAP table. However, for addresses out of the range of the VP_MAP
table, the address to which a breakpoint is set depends on the SH7729 or SH7709A MMU
status during command input. Even when the VP_MAP table is modified after breakpoint
setting, the address translated when the breakpoint is set valid.
An area other than the CS0 to 6 areas and the internal RAM area
An instruction in which Break Condition 2 is satisfied
A slot instruction of a delayed branch instruction
An area that can be only read by MMU
Notes on Using the JTAG Clock (TCK) and AUD Clock (AUDCK)
Notes on Setting the [Breakpoint] Dialog Box