HS7729KCI01H Renesas Electronics America, HS7729KCI01H Datasheet - Page 35

• Manufacturer Part Number: HS7729KCI01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America
• Type: In Circuit Debuggerr

Specifications of HS7729KCI01H

• Contents: E10A-LITE, Cable and CD-ROM
• For Use With/related Products: SH7729
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

2.2.2
(1) When the emulator is a PCI card:
(2) When the emulator is a PCMCIA card:
Notes: 1. For the SH7729, SH7729R, and SH7622 E10A emulators, there is a check box for
1. Shut the operating system down and turn off the power to the host computer.
2. Insert the PCI-card emulator in a slot on the host computer. Refer to section 2.3,
3. Start the host computer and log-on with an administrator-level user name.
4. Install the HDI. (For a component, be sure to select [PCI Card Driver]. There is a check
5. Restart the host computer.
1. Shut the operating system down and turn off the power to the host computer.
2. Insert the PCMCIA-card emulator in the host computer’s slot. Refer to section 2.3,
3. Start the host computer and log-on with an administrator-level user name.
4. During HDI installation, the setting value should be checked beforehand because inquiries
5. Install the HDI. (For a component, be sure to select [PC Card Driver (PCMCIA)]. There is
6.
Connecting the Card Emulator to the Host Computer.
box for selecting the type name of the product under the [PCI Card Driver] component.
Select the appropriate type name. If the correct name is not selected, the correct driver will
not be installed, and the emulator will not operate.)
Connecting the Card Emulator to the Host Computer.
are made about the resource used by the PCMCIA-card emulator.
Start the [Start] menu -> [Programs] -> [Administrative Tools (Common)] -> [Windows
NT Diagnostics], check the status of the IRQ, I/O port, and memory from the resource
panel, and determine the setting values that do not conflict with other devices. (The
following resources are used: IRQ: one channel, I/O port: H’F byte, and memory: H’4000
byte.)
a check box for selecting the type name of each product under the [PC Card Driver
(PCMCIA)] component. Select the appropriate type name. If the correct name is not
selected, the correct driver will not be installed and the emulator will not operate.)
2. The driver that has been selected in the [Drivers] component starts after the host
Restart the host computer.
Installing under Windows NT
selecting the MODEL name that appears on the component list. Select the correct type
name.
computer is initiated. If the host computer is initiated with the card disconnected or
with the incorrect driver installed, the driver cannot initiate and the service control
manager informs the system of an error. This, however, is not a problem.
®
4.0 Operating System
Rev. 2.0, 01/01, page 9 of 216