M68ICS08KX Freescale Semiconductor, M68ICS08KX Datasheet - Page 20

• Manufacturer Part Number: M68ICS08KX
• Description: SIM PROGRAM FOR 68HC908KX8/KX2
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS08KX

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC908KX8/KX2
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Preparation and Installation
2.2.1.3 Low Voltage Interrupt (LVI)
2.2.1.4 Internal Clock Generator (ICG)
2.2.2 Configuring the KXICS Jumper Headers
User’s Manual
20
CAUTION:
The LVI is disabled by default in monitor mode. It is enabled by a dummy write
to LVISR.
The ICG is bypassed in monitor mode, so it is not available for use.
The KXICS supports four configuration options: standalone, simulation,
evaluation, and programming.
Four jumper headers (Table 2-1) on the KXICS are used to configure the
hardware options.
The KXICS can be set to operate at a variety of voltages. When configuring the
KXICS jumper headers, care must be exercised to ensure that the voltages
selected for the board match those of the target device. Failure to do so can
result in damage to either or both of the pieces of equipment.
•
•
•
•
Standalone — ICS08KXZ.exe running on the host computer (the KXICS
is not connected.) Emulation of the MCU CPU, registers, and I/O ports
is done within the host computer environment.
Simulation — Host computer is connected to the KXICS via the RS-232
cable and ICS08KXZ.exe runs on the host computer, providing access to
the M68HC(9)08KX MCU CPU internal registers and I/O ports.
Evaluation — Host computer is connected to the KXICS, and the KXICS
is connected to the target system via the flex cable, providing limited
real-time evaluation of the MCU and debugging user developed
hardware and software.
Programming — Host computer is connected to the KXICS, and the
KXICS is connected to the target system via the MON08 cable with
PROG08SZ.exe used to program the MCU FLASH module. In the
programming mode there is limited evaluation (port A0 on the KX8 and
port B0 and port B1 on the KX8 are used for communications, so they
are unavailable for emulation).
Preparation and Installation
M68ICS08KX In-Circuit Simulator
MOTOROLA