M68ICS08KX Freescale Semiconductor, M68ICS08KX Datasheet - Page 61

• Manufacturer Part Number: M68ICS08KX
• Description: SIM PROGRAM FOR 68HC908KX8/KX2
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS08KX

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC908KX8/KX2
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Quick Start Hardware Configuration Guide
B.3 Installing the Software
User’s Manual
56
CAUTION:
NOTE:
Installation of a SOIC type MCU requires the use of the SOIC-to-DIP adapter
identified in Table 1-1 of this manual.
The SOIC-to-DIP adapter may be confusing to install. It must be placed into the
DIP socket, XU1, with the hinged side of the SOIC shell aligned at the bottom
of the KXICS board. This positioning will place the SOIC-type MCU socket pin
1 in the upper left corner of the SOIC socket.
For instructions for installing the ICS08 software, refer to P&E Microcomputer
Systems, Inc., M68ICS08KX In-Circuit Simulator Operator’s Manual.
2. Connect the board to the host PC.
3. Apply power to the board.
Locate the 9-pin connector labeled J6 on the board. Using the cable
provided, connect it to a serial COM port on the host PC.
Connect the 5-volt power supply to the round connector on the board, J2.
Plug the power supply into an ac power outlet, using one of the
country-specific adapters provided. (The KXICS green power LED on
the board should light when switch SW1 is in the ON position.)
Quick Start Hardware Configuration Guide
b. Install the SOIC-to-DIP adapter into the DIP socket XU1. Be sure
d. Open the hinged access door on the SOIC shell.
a. Place the pin tension arm of the KXICS DIP socket XU1 in the up
c. Place the pin tension arm of the KXICS DIP socket XU1 in the
e. Install the SOIC-type MCU into the SOIC socket of the adapter. Be
f. Close and secure the hinged access door on the SOIC shell.
position.
that the pin 1 orientation of the adapter aligns with the pin 1 location
on the DIP socket (upper left pin of the DIP socket).
down position to secure the pins of the adapter to the socket.
sure that the pin 1 orientation of the silkscreened dot on the MCU
aligns with the pin 1 location on the SOIC socket (upper left pin of
the socket).
M68ICS08KX In-Circuit Simulator
MOTOROLA