M68ICS08KX Freescale Semiconductor, M68ICS08KX Datasheet - Page 51

• Manufacturer Part Number: M68ICS08KX
• Description: SIM PROGRAM FOR 68HC908KX8/KX2
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS08KX

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC908KX8/KX2
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Using the MON08 Interface
4.3 Connecting to the In-Circuit Simulator
User’s Manual
46
Pin
No.
10
12
13
14
15
16
11
8
9
M68ICS08KX8
TGT-PTA1
TGT-PTB0
TGT-PTB1
Label
PTB0
PTB1
PTA0
PTA1
NC
NC
Table 4-1. MON08 Target System Connector J3 (Continued)
Using the 16-pin cable provided with the KXICS kit, connect one end of the
cable to the KXICS board at J3. Connect the other end to connector P1 on the
target-system board. The pin-1 indicators on each cable end must correspond to
the pin-1 indicators on the headers. P2 is not used when connecting to the
KXICS board.
Bidirectional
Bidirectional
Bidirectional
Bidirectional
Bidirectional
Bidirectional
Bidirectional
Direction
NC
NC
Using the MON08 Interface
Connect to MCU PTA0 pin. No other target-system logic should be
tied to this signal. Host I/O present on this pin.
Connect to user circuit that normally would be connected to PTA1
on the MCU.
Connect to MCU PTA1 pin. No other target-system logic should be
tied to this signal. Grounded during power-on reset and for 256
cycles after reset.
Connect to user circuit that normally would be connected to PTB0
on the MCU.
Connect to MCU PTB0 pin. No other target-system logic should be
tied to this signal. Held at +5 Vdc during power-on reset.
Connect to user circuit that normally would be connected to PTB1
on the MCU.
Connect to MCU PTB1 pin. No other target-system logic should be
tied to this signal. Grounded during power-on reset.
Not connected
Not connected
Target System Connection
M68ICS08KX In-Circuit Simulator
MOTOROLA