M68ICS08KX Freescale Semiconductor, M68ICS08KX Datasheet - Page 30

• Manufacturer Part Number: M68ICS08KX
• Description: SIM PROGRAM FOR 68HC908KX8/KX2
• Manufacturer: Freescale Semiconductor
• Type: Simulator/Programmerr

Specifications of M68ICS08KX

• Contents: Programmer, Power Supply, Assembler/Simulator/Debugger, Cable, Software and Documentation
• For Use With/related Products: 68HC908KX8/KX2
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Preparation and Installation
2.6 Installing the Software
User’s Manual
30
NOTE:
NOTE:
An MCU must be installed in the target system. No MCU should on the KXICS.
For more detailed information on the MONO8, refer to Section 4 of this manual.
For instructions for installing the ICS08 software, refer to P&E Microcomputer
Systems, Inc., M68ICS08 68HC08 In-Circuit Simulator Operator’s Manual,
Motorola document order number M68ICS08OM/D.
•
•
When emulating, connect the 40-pin M68CLB05A flex cable to the
connector labeled J1on the simulator board. Attach the other end of the
cable to the appropriate connector on the target system. Target head
adapters are available.
Emulating using a ribbon cable
When emulating, connect a 16-pin flat ribbon cable to connector J5 on
the simulator board. Attach the other end of the cable to the appropriate
connector on the target system.
Using a MON08 cable to debug the target system.
Connect the MON08 debug interface cable to the appropriate MON08
debug interface connector, J3, for communication with the target
system’s MCU. Attach the other end of the cable to the appropriate
connector on the target system.
Preparation and Installation
M68ICS08KX In-Circuit Simulator
MOTOROLA