MPC566EVB Freescale Semiconductor, MPC566EVB Datasheet - Page 20

• Manufacturer Part Number: MPC566EVB
• Description: KIT EVALUATION FOR MPC565/566
• Manufacturer: Freescale Semiconductor

Specifications of MPC566EVB

• Processor To Be Evaluated: MPC56x
• Data Bus Width: 32 bit
• Interface Type: RS-232, Ethernet
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Support Logic
1.3.7 Power Oak K/I/S Hardware Options
Several hardware options surround the Power Oak supply to allow the user access to many of the
features. The options are sorted by leading character to indicate functionality. ‘K’ designated
options refer to VKAM and MPC566 back-up supply options. ‘I’ designated options refer to
Interrupt operation options. ‘S’ designated options refer to MPC566 Reset or I/O signal connection
options. Following is the summary table (also refer to MPC566EVB schematic):
1-10
1. Compile and link as though the code was to be placed at the base of the internal flash, but
2. Set IP bit (Switch 5 ON).
3. Download to SRAM (If using serial or ethernet, start the ROM Monitor first. If using BDM
4. In the ROM Monitor, execute the 'upuser' command.
5. Turn off IP bit (Switch 5 OFF). User code should now be running from reset/POR.
Designator
setup so that it will download to the SRAM starting at address 0xFFF0_8000. The user
should refer to their compiler documentation for this, since it will depend upon the compiler
used.
via a wiggler cable, download first, then start ROM Monitor by pointing the program
counter (PC) to 0x0090_0100 and run.)
Option
K10
K11
K0
K1
K2
K3
K4
K5
K6
K7
K8
K9
I0
I1
I2
VKAM
2.6V
VKAM
2.6V
VKAM
+2.6V
VKAM
2.6V
VKAM
2.6V
VKAM
2.6V
WAKEUP
WAKEUP
PRERESET
Power Oak Signal
Freescale Semiconductor, Inc.
For More Information On This Product,
Table 1-3. K/I/S Option Table
MPC566EVB User’s Manual
Go to: www.freescale.com
KAPWR
VDDSRAM2
VDDSYN
VDDRTC
IRQ0
KAPWR
VDDSRAM1
VDDSRAM1
VDDSRAM2
VDDSRAM3
VDDSRAM3
VDDSYN
VDDRTC
IRQ4
IRQ0
MPC566
signal
K7
K6
K9
K8
K11
K10
Associated
Option
K1
K0
K3
K2
K5
K4
I2
I1
1
Closed, Note: REV B
board has 0 ohm resistor
installed
Closed
Open
Closed
Open
Closed
Open
Open
Closed
Closed
Open
Open
Open
Open
Open
Default Connection