FS-935 Digi International, FS-935 Datasheet - Page 13

• Manufacturer Part Number: FS-935
• Description: JTAG-BOOSTER FOR IDT64145 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-935

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: IDT64145 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for IDT 64145
Pins specified with /I2CCLK= and /I2CDATI= must have different
control cells
The pin specified with the option /I2CDATI= must be able to be switched to
high impedance while the pin specified with option /I2CCLK= is an active
output. See chapter 1.6 “Initialization file JTAG145.INI”.
Pins specified with /I2CDATO= and /I2CDATI= must have different
control cells
The pin specified with the option /I2CDATI= must be able to be switched to
high impedance while the pin specified with option /I2CDATO= is an active
output. See chapter 1.6 “Initialization file JTAG145.INI”.
Specify only one of that options:
Some options are exclusive (i.e. /8BIT and /16BIT). Don't mix them.
There are unknown parts in the JTAG chain. Please use the option
/IROFFS= to specify the instr. reg. offset of the CPU.
If there are unknown parts in the JTAG chain, the program isn’t able to
determine the logical position of the CPU’s instruction register.
There is no IDT RC64145 in the JTAG chain
No IDT RC64145 was found in the JTAG chain. Check the target power. Try
with option /DRIVER=4 again.
Value of option /FILE-OFFSET out of range
The value of the option /FILE-OFFSET= points behind end of file.
wrong driver #
The value specified with the option /DRIVER= is out of range.
wrong Identifier (xxxx)
No valid identifier found. Check the specified chip select signal and the bus
width. Try with the option /DEVICE= .
JTAG145a.doc
13