FS-935 Digi International, FS-935 Datasheet - Page 31

• Manufacturer Part Number: FS-935
• Description: JTAG-BOOSTER FOR IDT64145 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-935

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: IDT64145 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.2.
Usage:
The contents of a flash device is read and written to a file.
The type of flash device is normally detected by the software. When autodetect
fails you should use the /DEVICE= option to set the right flash device. The
known devices are shown in chapter 1.7 “Supported flash devices”.
Options:
/DEVICE=devicename
See function /P (Chapter 2.1)
/NOMAN
See function /P (Chapter 2.1)
/DEVICE-BASE=hhhhhh
See function /P (Chapter 2.1)
/OFFSET=hhhhhh
Reading of the flash memory starts at an offset of hhhhhh relative to the start
address of the flash device. If the offset is negative, the offset specifies a
address relative to the end of the flash device.
See also option /TOP.
Default:
Abbreviation:
/TOP
If the option /TOP is used the option /OFFSET= specifies the address where
reading ends (plus one) instead of the starting address.
/LENGTH=hhhhhh
The number of read bytes may be limited to LENGTH. If no LENGTH is
specified the whole flash device is read (if no offset is specified).
2
JTAG145a.doc
hhhhhh=number base is hex
Read a Flash Device to file
JTAG145 /R filename [optionlist]
/OFFSET=0
/O=
2
31