FS-935 Digi International, FS-935 Datasheet - Page 36

• Manufacturer Part Number: FS-935
• Description: JTAG-BOOSTER FOR IDT64145 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-935

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: IDT64145 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2.5.
Usage:
The specified file is programmed to an I²C-Device (i.e. a serial EEPROM)
connected to pins of the CPU. Finally a complete verify is done. If the verify
fails, the contents of the I²C-Device is written to a file with the extension DMP.
Two methods to connect the I²C-Device to the CPU are supported. The first
method is to use two CPU pins, one pin for clock output (I2CCLK) and one pin
for serial data input and output (I2CDAT). The second method is to use one pin
for clock output (I2CCLK), one for serial data input (I2CDATI) and one for serial
data output (I2CDATO).
Options:
/DEVICE-BASE=hhhhhh
By default a device start address of 3000000h (=48MByte) is used for accesses
to the flash device.
Default:
Abbreviation:
/OFFSET=hhhhhh
The programming starts at an offset of hhhhhh relative to the start address of
the I²C-Device.
Default:
Abbreviation:
/FILE-OFFSET=hhhhhh
If FILE-OFFSET is specified, the first hhhhhh bytes of the file are skipped and
not programmed to target.
Default:
Abbreviation:
4
36
hhhhhh=number base is hex
Program an I²C-Device
JTAG145 /PI2C filename [optionlist]
/DEVICE-BASE=3000000
/DB=
/OFFSET=0
/O=
/FILE-OFFSET=0
/FO=
4
JTAG145a.doc