R5F212B7SNFP#U0 Renesas Electronics America, R5F212B7SNFP#U0 Datasheet - Page 136

• Manufacturer Part Number: R5F212B7SNFP#U0
• Description: IC R8C/2B MCU FLASH 64-LQFP
• Manufacturer: Renesas Electronics America
• Series: R8C/2x/2Br

Specifications of R5F212B7SNFP#U0

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: POR, PWM, Voltage Detect, WDT
• Number Of I /o: 55
• Program Memory Size: 48KB (48K x 8)
• Program Memory Type: FLASH
• Ram Size: 2.5K x 8
• Voltage - Supply (vcc/vdd): 2.2 V ~ 5.5 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 64-LQFP
• For Use With: R0K5212D8S001BE - KIT STARTER FOR R8C/2DR0K5212D8S000BE - KIT DEV FOR R8C/2D
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

R8C/2A Group, R8C/2B Group
Rev.2.00
REJ09B0324-0200
10.5.3
Table 10.4
Key input interrupt
INT0 to INT3 interrupt
Timer RA interrupt
Serial interface interrupt
Voltage monitor 1 interrupt
Voltage monitor 2 interrupt
10.5.3.1
10.5.3.2
Since the oscillator circuits stop in stop mode, the CPU clock and peripheral function clock stop and the CPU
and peripheral functions that use these clocks stop operating. The least power required to operate the MCU is in
stop mode. If the voltage applied to the VCC pin is VRAM or more, the contents of internal RAM is
maintained.
The peripheral functions clocked by external signals continue operating.
Table 10.4 lists Interrupts to Exit Stop Mode and Usage Conditions.
The MCU enters stop mode when the CM10 bit in the CM1 register is set to 1 (all clocks stop). At the same
time, the CM06 bit in the CM0 register is set to 1 (divide-by-8 mode) and the CM15 bit in the CM1 register is
set to 1 (XIN clock oscillator circuit drive capacity high).
When using stop mode, set bits OCD1 to OCD0 to 00b before entering stop mode.
The status before wait mode was entered is maintained.
However, when the CM13 bit in the CM1 register is set to 1 (XIN-XOUT pins), the XOUT(P4_7) pin is held
“H”. When the CM13 bit is set to 0 (input ports P4_6 and P4_7), the P4_7(XOUT pin) is held in input status.
Nov 26, 2007
Stop Mode
Interrupt
Interrupts to Exit Stop Mode and Usage Conditions
Entering Stop Mode
Pin Status in Stop Mode
Page 114 of 580
−
Can be used if there is no filter
Can be used if there is no filter when external pulse is counted in event
counter mode
When external clock is selected
Usable in digital filter disabled mode (VW1C1 bit in VW1C register is set
to 1)
Usable in digital filter disabled mode (VW2C1 bit in VW2C register is set
to 1)
Usage Conditions
10. Clock Generation Circuit