AC4486-5M Laird Technologies, AC4486-5M Datasheet - Page 27

• Manufacturer Part Number: AC4486-5M
• Description: TXRX 868MHZ 3V TTL 5MW RS232
• Manufacturer: Laird Technologies
• Series: AeroCommr

Specifications of AC4486-5M

• Frequency: 868MHz
• Data Rate - Maximum: 115.2kbps
• Modulation Or Protocol: FSK
• Applications: AMR, Gaming Devices, Inventory Tracking
• Power - Output: 5mW
• Sensitivity: -100dBm
• Voltage - Supply: 3.3V
• Current - Receiving: 30mA
• Current - Transmitting: 40mA
• Data Interface: Connector, 2 x 10 Header
• Antenna Connector: MMCX
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Board Size: 49 mm x 42 mm x 5 mm
• Output Power: 5 mW
• Antenna: External MMCX Connector
• Frequency Rf: 869.65MHz
• Transmit Power: 5mW
• Interface Type: Serial
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

AC4486 Specifications
4.6.6 Sleep Walk Power-Down Command
After the Host issues the power-down command to the transceiver, the transceiver will de-assert the
In_Range line after entering power-down. A Client transceiver in power-down will remain in sync with a
Server for a minimum of 2 minutes. To maintain synchronization with the Server, this Client transceiver
should re-sync to the Server at least once every 2 minutes. This re-sync is accomplished by issuing
the Power-Down Wake-Up Command and waiting for the In Range line to go active. Once this occurs,
the Client transceiver is in sync with the Server and can be put back into power-down. This command
is only valid for Client transceivers.
Host Command:
Transceiver Response:
4.6.7 Sleep Walk Power-Down Wake-Up Command
The Power-Down Wake-Up Command is issued by the Host to bring the transceiver out of power-
down mode.
Host Command:
Transceiver Response:
4.6.8 Broadcast Mode
The Host issues this command to change the transceiver operation between Addressed Mode and
Broadcast Mode. If addressed mode is selected the transceiver will send all packets to the transceiver
designated by the Destination Address programmed in the transceiver. If Broadcast mode is selected,
the transceiver will send its packets to all transceivers on that network.
Host Command:
Transceiver Response:
01/21/05
Byte 1 = CCh
Byte 2 = 06h
Byte 1 = CCh
Byte 2 = RF Channel Number
Byte 1 = CCh
Byte 2 = 07h
Byte 1 = CCh
Byte 2 = RF Channel Number
Byte 1 = CCh
Byte 2 = 08h
Byte 3 = 00 for addressed mode, 01 for broadcast mode
Byte 1 = CCh
Byte 2 = 00 for addressed mode, 01 for broadcast mode
27