WM8510GEDS/V Wolfson Microelectronics, WM8510GEDS/V Datasheet - Page 47

• Manufacturer Part Number: WM8510GEDS/V
• Description: Audio CODECs VoIP Mono CODEC
• Manufacturer: Wolfson Microelectronics

Specifications of WM8510GEDS/V

• Operating Supply Voltage: - 0.3 V to + 7 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SSOP-28
• Minimum Operating Temperature: - 25 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Production Data
Headphone Output using DC Blocking Capacitors:
Figure 23 Recommended Headphone Output Configurations
w
HEADPHONE OUTPUT
The speaker outputs can drive a 16Ω or 32Ω headphone load, either through DC blocking capacitors,
or DC coupled without any capacitor.
When DC blocking capacitors are used, then their capacitance and the load resistance together
determine the lower cut-off frequency, f
response. Smaller capacitance values will diminish the bass response. Assuming a 16Ω load and
C1, C2 = 220µF:
f
In the DC coupled configuration, the headphone “ground” is connected to the MONOOUT pin. The
MONOOUT pin can be configured as a DC output driver by setting the MONOMUTE register bit. The
DC voltage on MONOOUT in this configuration is equal to the DC offset on the SPKOUTP and
SPKOUTN pins therefore no DC blocking capacitors are required. This saves space and material
cost in portable applications.
It is recommended to connect the DC coupled outputs only to headphones, and not to the line input
of another device. Although the built-in short circuit protection will prevent any damage to the
headphone outputs, such a connection may be noisy, and may not function properly if the other
device is grounded.
MONO OUTPUT
The mono output, can be used as a line output, a headphone output or as a pseudo ground for cap-
less driving of loads by SPKOUT. Recommended external components are shown below.
Figure 24 Recommended Circuit for Line Output
The DC blocking capacitors and the load resistance together determine the lower cut-off frequency,
f
f
Increasing the capacitance lowers f
the bass response. The function of R1 is to protect the line outputs from damage when used
improperly.
c
c
c
. Assuming a 10 kΩ load and C1 = 1µF:
= 1 / 2π R
= 1 / 2π (R
L
L
C
+R
1
= 1 / (2π x 16Ω x 220µF) = 45 Hz
1
) C
1
= 1 / (2π x 10.1kΩ x 1µF) = 16 Hz
c
, improving the bass response. Smaller values of C1 will diminish
c
DC Coupled Headphone Output:
. Increasing the capacitance lowers f
PD, Rev 4.5, September 2008
c
, improving the bass
WM8510
47