CS1D-IC102D Omron, CS1D-IC102D Datasheet - Page 90

• Manufacturer Part Number: CS1D-IC102D
• Description: CS1D Dual IO Control Unit
• Manufacturer: Omron

Specifications of CS1D-IC102D

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

2-4-2
CPU Units
Note: An Inner Board can be
mounted in a Single CPU System.
Inner Board
Connector
Install an Inner
Board. (See note.)
Peripheral Port
Connects
Programming
Device (including
Programming
Console) host
computer, etc.
Refer to 2-6.
RS-232C Port
Connects CX-
Programmer (but not
Programming
Console), host
computer, external
devices,
Programmable
Terminal (PT), etc.
Refer to 2-6.
Components
Memory Card
Install into the active CPU Unit.
Note In a Duplex CPU System, the DIP switch on the front panel of the active CPU
DIP Switch
S Y S M A C
C S 1D -C P
PR OG RA MM ABL
P E R IP
Memory Card
Connector
Pin 1: User program memory write (enable: OFF; disable: ON)
Pin 2: Automatic user program transfer at startup (not transferred: OFF; transferred: ON)
Pin 3: Always OFF.
Pin 4:
Pin 5:
Pin 6:
Pin 7:
Pin 8: Always OFF.
M C P W
P O R T
H E R A
E CO NTR OLL
U 67 H
R
Unit is enabled (and the one on the standby CPU Unit is disabled). The DIP
switch settings on the active and standby CPU Units do not necessarily have
to match. Even if they do not match, operation in Duplex Mode is still possible.
L
O PE N
ER
B U S Y
Easy backup (read/write from Memory Card) with pin 7 ON and pin 8 OFF.
Easy backup (verification with Memory Card) with pin 7 OFF and pin 8 OFF.
Refer to DIP Switch Settings.
View with battery housing opened.
Memory Card
Powered/Accessed Indicators
MCPWR (ON: green)
Power provided to Memory
Card.
BUSY (ON: Yellow)
Memory Card being accessed.
Memory Card Power Supply
Button
Press this button to turn OFF
the power supply before
removing the Memory Card or
when performing the simple
backup operation.
Memory Card Eject Button
Press to remove the Memory
Card.
RUN
Lit green when the CPU Unit is
operating normally in MONITOR or
RUN mode.
ERR/ALM
Lit read when a fatal error was
discovered in self-diagnosis or a
hardware error has occurred. The CPU
Unit will stop operating and all outputs
will be turned OFF.
Flashing red when a non-fatal error
was discovered in self-diagnosis.
The CPU Unit will continue operating.
INH
Lit yellow when the Output OFF Bit
(A50015) has been turned ON. The
outputs from all Output Units will turn
OFF.
BKUP
Lit yellow when data is being
transferred between RAM and flash
memory.
Do not turn OFF the power supply to
the PLC while this indicator is lit.
PRPHL
Flashes yellow when the CPU Unit is
communicating (sending or receiving)
via the peripheral port.
COMM
Flashes yellow when the CPU Unit is
communicating (sending or receiving)
via the RS-232C port.
MCPWR
Lit green when power is being supplied
to the Memory Card.
BUSY
Flashes yellow when the Memory Card
is being accessed.
Section 2-4
55