TMPM363F10FG Toshiba, TMPM363F10FG Datasheet - Page 709

• Manufacturer Part Number: TMPM363F10FG
• Manufacturer: Toshiba

Specifications of TMPM363F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 100
• Package: LQFP(14x14)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 4
• Uart/sio (ch): 5
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: 8
• 10-bit Ad Converter: 8
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

24.2.4
24.2.5
TMPM363F10FG
Product Name
figuration shown below.
SET pin (high).
mode, the internal flash memory is mapped to 0x3F80_0000 and later addresses, and the Internal boot ROM
(Mask ROM) is mapped to 0x0000_0000 through 0x0000_0FFF.
To execute the on-board programming, boot the TMPM363F10FG with Single Boot mode following the con-
Set the RESET input to "0", and set the each BOOT (PI0) pins to values shown above, and then release RE-
Figure 24-3 shows a comparison of the memory maps in Normal and Single Boot modes. In Single Boot
The internal flash memory and RAM addresses of each device are shown below.
Configuration for Single Boot Mode
Memory Map
(6)
ble between the host and the target board. Turn on the power again so that the TMPM363F10FG re-
boots in Single-Chip (Normal) mode to execute the new program.
When programming of the flash memory is complete, power off the board and disconnect the ca-
Step-6
Flash Size
1024 KB
(
TMPM363F10FG
Boot ROM
New Application
Program Code
flash memory
RAM Size
64 KB
)
BOOT(PI0) = 0
RESET = 0 → 1
(Single Chip / Single Boot Mode)
0x3F80_0000 to 0x3F8F_FFFF
0x0000_0000 to 0x000F_FFFF
Page 683
(I/O)
Flash Address
SIO4
RAM
(Host)
0 → 1 RESET
Set to Single-Chip
mode
(BOOT=1)
0x2000_0000 to 0x2000_FFFF
RAM Address
TMPM363F10FG