TMPM364F10FG Toshiba, TMPM364F10FG Datasheet - Page 492

• Manufacturer Part Number: TMPM364F10FG
• Manufacturer: Toshiba

Specifications of TMPM364F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 144
• Package: LQFP(20x20)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 5
• Uart/sio (ch): 12
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 16
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

14.5
Control in the I2C Bus Mode
14.5.15
14.5.16
al bus interface circuit. After a reset, all control registers and status flags are initialized to their reset values.
When the serial bus interface is initialized, <SWRST> is automatically cleared to "0".
The SBIxBR0<I2SBI> register determines if the SBI operates or not when it enters the IDLE mode.
This register must be programmed before executing an instruction to switch to the standby mode.
If the serial bus interface circuit locks up due to external noise, it can be initialized by using a software reset.
Writing "10" followed by "01" to SBIxCR2<SWRST[1:0]> generates a reset signal that initializes the seri-
Note:A software reset causes the SBI operating mode to switch from the I2C mode to the port mode.
Baud Rate Register (SBIxBR0)
Software Reset
Page 466
TMPM364F10FG