TMPM364F10FG Toshiba, TMPM364F10FG Datasheet - Page 73

• Manufacturer Part Number: TMPM364F10FG
• Manufacturer: Toshiba

Specifications of TMPM364F10FG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 1024K
• Rom Type: Flash
• Ram (kbytes): 64K
• Number Of Pins: 144
• Package: LQFP(20x20)
• Vcc: 3V
• Cpu Mhz: 64
• Ssp (ch) Spi: 1
• I2c/sio (ch): 5
• Uart/sio (ch): 12
• Usb: Host
• Can: 1
• Ethernet: -
• External Bus Interface: Y
• Cs/wait Controller (ch): 4
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: 16
• 12-bit Ad Converter: -
• 16-bit Timer / Counter: 16
• Motor / Igbt Control: -
• Real Time Clock: Y
• Watchdog Timer: Y
• Osc Freq Detect: -
• Clock Gear: Y
• Low-power Hold Function: Y
• Remote Control Interface: Y
• Hardware Cec Controller: Y
• Comparators: -
• Low-voltage Detector: -
• Etm Hardware Trace: 4-bit

6.3.5
<example> Transition from SLOW mode to NORMAL mode
CGOSCCR<WUPT[11:0]> = "0x9C4"
Read CGOSCCR<WUPT[11:0]>
CGOSCCR<XEN>="1"
CGOSCCR<WUEON>="1"
Read CGOSCCR<WUEF>
CGOSCCR<SYSCK>="0"
Read CGOSCCR<SYSCKFLG>
CGOSCCR<XTEN>="0"
The warm-up function is used when returning from STOP / BACKUP mode. For detail function, describes
in "6.6.8 Warm-up".
ware (instruction).
Warm-up function
The warm-up function secures the stability time for the oscillator and the PLL with the warm-up timer.
This shows the setting of warm-up function.
Specify the count up clock for the warm-up counter in the CGOSCCR<WUPSEL>.
The warm-up time can be set by setting CGOSCCR<WUPT><WUPTL>.
The CGOSCCR<WUPT><WUPTL> is used to confirm the start and completion of warm-up through soft-
For the clock changing, current system clock can be monitored in CGCKSEL<SYSCKFLG>.
The following shows the warm-up setting and example.
<example 1>Setting 5 ms of warm-up time with 8MHz oscillator
Drop the last 4 bits, set 0x9C4 into the CGOSCCR<WUPT[11:0]>.
The following shows the warm-up setting.
: Warm-up time setting
: Check warm-up counter setting
: Enable high-speed oscillation (fosc)
: Enable warm-up counting (WUP)
: Wait for "0" (end of WUP)
: system clock changed to high-speed (fgear)
: Wait for "0" (the current clock is fgear)
: Disable the low-speed oscillation (fs)
(In dual clock mode, it’s not required.)
Page 47
TMPM364F10FG